answersLogoWhite

0

The 2002 Ford Ranger camshaft position sensor is located on the back of the camshaft. The rear engine plate will need to be removed in order to view the sensor.

User Avatar

Wiki User

10y ago

What else can I help you with?

Related Questions

Where is the camshaft position sensor located on a 1999 ranger 4.0 v-6?

Where is the camshaft position sensor located on a 1999 ford ranger 4.0 liter engine


Where is the camshaft position sensor located on a 2002 Daewoo laganza?

The camshaft position sensor is located on the end of the camshaft housing, on a 2002 Daewoo. The sensor should be labeled as such.


Where is the camshaft position sensor located on a 2000 ford ranger?

its on the top of the cylinder block behind the intake manifold


Where is the camshaft position sensor located on 1990 Lexus ls400?

Where is the camshaft position sensor located on 1990 Lexus ls400?


Where is camshaft position sensor on 5.7 Vortec?

The Camshaft sensor is located in the distributor.


Where is the camshaft position sensor on a 2006 Chevy HHR?

Do you have a video of the hhr camshaft position sensor


Where is the Camshaft Position Sensor located in the 1996 Oldsmobile Achieva?

The Camshaft Position Sensor is located behind the Power Steering Pump.


Where is the camshaft position sensor located on a 1999 Oldsmobile Intrigue and how do you replace it?

where is the camshaft position sensor located on a 1999 Oldsmobile intrigue


Where is the camshaft position sensor located on a 2003 Nissan Sentra GXE?

Where is the camshaft position sensor located on a 2003 Nissan Sentra GXE?


Where is the camshaft position sensor located on a 2002 Daewoo Leganza engine?

The camshaft position sensor is located in the engine compartment of the 2002 Daewoo Leganza. It is at the end of the camshaft housing.


Where is the Camshaft Position Sensor located on a 2002 Hyundai Sonata V6?

The camshaft position sensor on your 2002 automobile is located on the front of the camshaft. You will need to remove the front engine cover to access the sensor.


Where is the camshaft position sensor located on a 96 Mercury Mystique - Ford Contour?

Where is the camshaft position sensor located on a 98 Mercury Mystique 2.4??

Trending Questions
Why does your 84 back fire after tune up any one know where all vacuum lines go your camaro ran better when 2 of the6 spark plug wires were off please help? What should a 350 Chevy rev at 60 mph? Where is the torque converter in the transmission? What does the ets button stand for on a 2001 Pontiac grand am se? Can you tow a 5 spd manual 4x4 Geo Tracker without removing driveshaft? Why on a 1997 Chev Blazer with new thermostat and water pump rad also drained and refilled a couple of times and it is still overheating any help and or ideas? Where is a vehilce speed sensor on a gmc Yukon 1996 5.7 liter 4 wheel drive? Can a turbo or supercharger fit in a 2008 dodge avenger and how much will it cost to put it into a AWD verison? What will happen if you remove all the air from a car tire and place it into a large tractor tire? You have 1998 Chevy s10 blazerLS The turn signals and hazard flashers do not work Fuses checked They are good Replaced 1 combination hazard flasher located behind glove box but still no change? How do you change 2003 dodge ram heater control lights? Which is the fuse for turn signal on 2004 jeep grand Cherokee? Where is the water pump located at on 2001 neon? 3.1 liter head bolt torque specs? How to fix a stuck rear door on a Pontiac Transport 1998? How do you change a oil sending unit on a 2001 Chevy 4.3? What are the timing marks for a 1993 2 liter Audi 80? How much oil to put in a 97 grand Marquis? 1996 ford E 350 7.3 ran out of fuel now cant start runs on either? What should you do when your 1998 Dodge Ram gauges don't work?