answersLogoWhite

0

It will be on the front of the engine, normally just above the crankshaft pully

User Avatar

Wiki User

10y ago

What else can I help you with?

Related Questions

If your camshaft sensor is bad will your car start?

no


Where is the camshaft position sensor for a 2002 Mitsubishi galant 2.4L 4 clyinder?

Where can I find the camshaft sensor for my car 2002 mitubishi galant es 4 clyinder


How do you replace the camshaft sensor on a 1996 Suzuki Sidekick Sport?

Locate the camshaft sensor in your car. Disconnect the electrical plug on the sensor. Remove the bolt that holds it in place. Twist the the sensor to remove it and place in the new one.


What a camshaft sensor does?

cheap back up to crank sensor. it may allow the car to run with out crank sensor, though poorly


Will the camshaft sensor stop the car from starting?

Yes. Cam sensor will determine the rotation of the camshaft, and if it does not sense it 'turning' the sensor will not allow the engine to start (it protects damaging the engine). Faulty camshaft or crankshaft sensors will stall engine and prevent restart until replaced.


Camshaft Position Sensor on a Nissan Xtrail?

location of the camshaft sensor


Can a camshaft position sensor cause car to stall?

it can, but i would check the ignition control module first....then the crank sensor.....


What are the symptoms of a bad camshaft position sensor?

It is important to recognize when poor performance is due to a bad car part. Symptoms of a bad camshaft sensor are misfiring, hesitation during acceleration, and not starting.


What does the camshaft sensor do?

Camshaft Sensor is used to adjust the timing to to belt stretch


Where is camshaft position sensor on 5.7 Vortec?

The Camshaft sensor is located in the distributor.


Is there a camshaft sensor in the 1988 Chevy Celebrity 2.8L?

No, there is no camshaft sensor on that model.


Where is the camshaft sensor on a 2003 Saturn Vue?

The 2003 Saturn camshaft sensor can be found on the back of the cylinder head. The camshaft sensor should be labeled as such.