0
Where is the camshaft sensor located on a 2002 Chrysler sebring 2.7 liter engine?
Wiki User
∙ 12y ago
i replaced mine on a 2001 sebring sedan lxi, when you face the front of the car, it is on the left side of your engine, down between the coolant reservoir and the engine side. there is a black plug that covered the bolt on mine. I had to get a 13mm "long shaft" lug to get it unscrewed. if it is a tight area for your hands, you may have to partially remove the coolant reservoir (have another bottle of coolant ready, in case you lose a lot from removing it.
Wiki User
∙ 12y ago
Add your answer:
Earn +20 pts
Where does the 1997 Chrysler sebring knock sensor located?
The Chrysler Sebring knock sensor is located in the engine valve or cylinder located at the back of the motor. This part is in this position next to the engine valve so the sensor can feel the vibration of the engine.
Where is the ecm located in a 2000 Chrysler sebring jxi?
The PCM is located in the actual engine bay on a 2000 Chrysler Sebring. It is mounted vertically next to the battery tray.
Where is the reset button located on the 2002 Chrysler Sebring 2.7 engine?
No reset buttons on a Chrysler.
Where is the PCM located on a 2001 Chrysler Sebring?
It is located on the right side of the engine (facing the engine ) near the the fuse box.
Where is the radiator located in a Chrysler sebring convertible?
It is under the hood, between the engine and grill.
Where is the camshaft position sensor located on a 2004 Chrysler sebring convertible?
Well i'm not sure which engine you have, but i have an 04 Sebring Sedan, 2.4L DOHC (4cyl). and mine was located on the top of the engine right hand side of the head. It took me all of 5 minutes to take off and put the new one on. Good luck Nikki
Where is the fuse box in a 2004 Chrysler Sebring?
The 2004 Chrysler Sebring fuse box is located in the engine compartment. The fuse box will be on the drivers side behind the battery box.
Where is the starter located on a 2003 Chrysler Sebring convertible limited?
It is behind the engine mount on the radiator side of the engine.
Where is the water pump located on a 1999 Chrysler Sebring?
in the front of engine it is driven by the timing belt.
Where is the cruise control module located on a 1996 Chrysler sebring?
The engine computer controls the cruise.
Where is the factory anti theft alarm on a 2002 Chrysler Sebring?
It is located in the body and engine computers.
Where is the voltage regulator located on a 2007 Chrysler sebring?
it is integral to the engine computer and is not serviced separately.
