answersLogoWhite

0

I am not quite sure how to answer this question........Maybe you meant a 1983 model?...

Ford changed to fuel injection in the late 1987 model's. Early 1987 was the last of the carb's. And this is port injection, and not throttle body.

User Avatar

Wiki User

17y ago

What else can I help you with?

Related Questions

Does a 1993 Mercury Villager have a carburetor?

Yes, the 1993 Mercury Villager was a 1992 Nissan Quest. The last year Nissan used a Carburetor on a Quest. Fuel injection system replaced the carburetor in 1993.


Diagram of brake lines on 1993 topaz?

need diagram of rear brake lines for 1993 mercury topaz


Are photos available for a 1993 Mercury Topaz water pump install?

Photos might be available online through forums, websites, or repair guides that detail the steps for installing a water pump on a 1993 Mercury Topaz. You can search for "1993 Mercury Topaz water pump installation guide" or "1993 Mercury Topaz water pump replacement" to find detailed instructions and possibly photos to help with the process.


1993 Mercury Topaz sucks air how to fix?

yes


Does a 1993 Mercury Topaz have a timing chain?

On a 1993 Mercury Topaz : Yes , both the 2.3 litre four cylinder engine and the 3.0 litre V6 engine use a timing CHAIN


Does the 1993 mercury topaz have a cigarette lighter?

Yes. Not an acessory outlet.


How many fuel filter are they in mercury topaz 1993?

Should be just one.


Where is fuel pump located on 1993 mercury topaz?

Inside the fuel tank.


How do you know when you have enough tension on a serpentine belt For a 1993 Mercury Topaz?

when the belt has no slack in it


How do you Replace the Horn on a 1993 Mercury Topaz?

Horn's should be in the fender wells in the engine compartment.


When was Mercury Topaz created?

Mercury Topaz was created in 1983.


How do you change out a fan relay for a 1993 Mercury topaz?

To change out a fan relay for a 1993 Mercury Topaz, locate the relay, typically found in the engine compartment near the radiator. Disconnect the negative battery cable, remove the old relay, and insert the new one in its place. Reconnect the negative battery cable and test the fan to ensure the new relay is functioning correctly.