0
What else can I help you with?
How do you adjust clutch on 1993 Mazda Protege DX which has to be pushed all the way in and shifted carefully and hydraulic cylinder cannot be located under hood for adding fluid?
The clutch master cylindar should be right beside the brake master cylindar. I have run across a couple of cars that have the brakes on the passenger side but never the clutch. I assume this holds true for your car. As far as adjusting a hydraulic clutch, they don't. If the clutch is not pushing in enough, it is usually the slave cylindar which is located on the bell housing of the transmission. They get worn and need to be replaced.
Were do i pour the clutch fluid in my 1993 probe gt?
Clutch master cylinder reservoir.
Change a clutch on a 1993 jeep wrangler 4.0?
How to change a clutch and master cylinder on a 93 jeep wrangler
How do you find out if you have a mechanical clutch or hydraulic for my 1993 ford explorer?
It's a hydraulic clutch ( the clutch fluid reservoir is near the brake master cylinder )
How do you replace a 1993 Camaro clutch master cylinder?
the master clutch cylinder , losen bolt inside fire wall to the end do not remove nuts at this time , attatach wire to it and lower it to the ground
How do you replace the clutch master cylinder on a 1993 Toyota Paseo?
To replace the clutch master cylinder on a 1993 Toyota Paseo, first, disconnect the negative battery terminal and remove the clutch fluid reservoir cap. Then, detach the hydraulic lines from the master cylinder and unbolt it from the firewall. Install the new master cylinder by reversing the removal process, ensuring all connections are secure and refilling the reservoir with the appropriate fluid. Finally, bleed the clutch system to remove any air before testing the clutch operation.
How do you replace the clutch for a 1993 Mitsubishi Eclipse?
you will have to remove the transmission. once you have the tranny off you can remove and replace the clutch...if you buy a new clutch specific directions will come with it...too long to write here.
Where is the clutch master cylinder located and how do you replace it in a Ford Escort LX 1993?
Shared with the brake fluid.
Where is the Clutch master cylinder reservoir located on your 1993 probe gt?
Drivers side, near the brake master cylinder, Look for a cap that screws on.
How do you change a clutch cable on a 1993 Saab 9000 cse?
You don't because there isn't one. Your car has a hydraulic clutch--there's a master cylinder on the pedal and a clutch cylinder on the side of the transmission.
Is the clutch in the 1993 ford ranger a hydraulic clutch?
yes it is with the slave cylinder being inside the bee housing. the clutch master cylinder reservior is to the right facing the firewall. it requires brake fluid
Why would a 1993 Nissan 300ZX not go into gear?
The most probable cause is that the clutch is either not releasing; master/slave cylinder not working, or the clutch itself is damaged.
