Add your answer:
Where is the fuse box located on a 1991 Chevy S10 pickup?
mine is located on the drivers side of the dash
Where is the Vehicle Speed Sensor located in a 1991 Chevy s10 blazer?
The VSS is located in the top left hand side of the transfer case.
Does a Chevy s10 2.2 have a coil or distribulator cap?
It has a coil pack but no distributor.
How do you replace outside window weather strip 1991 Chevy s10?
1991 Chevy s10 how to replace outside window weather strip
Were is the electronic ignition module at on your 1996 Chevy s10 truck?
If this is the 4.3 engine, it is located on the bracket next to the ignition coil.
Where is the fuel pump located at on a 1991 Chevy s10 2wd maunal transmission 2.8?
Inside the fuel tank
Where is the temperature sensor in 1991 Chevy S10?
If it has a 4.3L engine the temp sensor is located next to the thermostat housing.
Will a 1991 Chevy blazer transmition fit in a 1995 Chevy s10?
No it will not SORRY.
Where is the thermosat located on a 1944 Chevy S-10?
there is no thermosat on a 1944 Chevy s10. For that matter there is no 1944 Chevy S10
Does a 1991 Chevy s10 pickup have an inertia switch?
No it does not. Chevy did not use them in that year on there trucks.
What is the wheel bolt pattern on a 1991 Chevy S10?
5x4.75
Does a 1991 Chevy S10 have a clutch cable or is it hydraulic?
Hydraulic.
Where is the mass air flow sensor located on 91 Chevy s-10?
You won't find one. The 1991 Chevy S10 doesn't have a MAF sensor.
Where is the iddle sensor on a 1991 s10 4.3?
The idle sensor on a 1991 S10 4.3 can be located at the engine bay.
Where is the horn relay on a 86 Chevy S10 located?
does anyone know where the horn relay switch is on a 86 chevy S10?
Where is coil for the ignition system on a Chevy s10 1987?
HEI? inside the distributor cap
How do you replace the evaporator coil on a 1995 s10 Chevy pickup?
take to your chevrolet dealer
Help cannot unlock the sterring wheel car 1991 s10 blazer?
Cannot unlock steering wheel on 1991 S10 Chevy blazer.
Where is the oil filter located on a 1991 Chevy 4WD S10 4.3L V6 pickup?
It is in the front bottom, there should be a scuff cover covering it.
On a 1991 Chevy S10 Pickup where would the manifold hose be located?
Sorry, There are about 30 answers to that question, Which one?. Good luck, Jamison
Where is the distributor located on a 1991 Chevy S10 Blazer?
4.3? Follow the spark plug wires from the spark plugs, they will lead you right to the distributor.
Where is the idle air control valve located on a 1991 Chevy s10 2.8l v6 engine?
It should be attached to the base of the throttle body.
Where is the fuel pump on a 1991 Chevy s10 blazer?
in the gas tank
Where is the ECM located in a 1992 Chevy S10 blazer?
The ECM on a 1992 S10 Blazer is located below the glove box.
Wiring schematic for O2 sensor on 1991 s10 Chevy blazer?
Haynes makes a manual with the wiring schematic for the O2 sensor on a 1991 Chevy Blazer S10. The manual can be found at most book stores.
Get the Answers App
