One end of the powertrain control module is visible from your engine compartment.It passes through the firewall on your passenger side. The rest of the PCM module is "hidden" under your dash behind your glove compartment.
In a 2000 Eddie Bauer Ford Expedition, the computer module is located under the dashboard and to the left of the brake pedal. The module should be cream-colored.
find body control module its on that
On 1991 and 1992 Ford Explorer's , the powertrain control module (PCM) is located in the right front passenger area behind the right side kick panel by the passenger's right foot.
In a 2009 Ford Explorer Eddie Bauer, the computer module, commonly referred to as the Powertrain Control Module (PCM), is typically located in the engine compartment. Specifically, it can be found near the battery, mounted on the driver's side fender well. Accessing it may require removing some components for better visibility. Always refer to the vehicle's service manual for precise instructions.
on the module located behind the passenger rear seat under the carpet
In a 2006 Ford Explorer Eddie Bauer edition, the airbag module is typically located under the center console or in the dashboard area, near the steering column. It may also be found beneath the driver's seat or in the passenger side dashboard, depending on the specific configuration. For precise identification, consulting the vehicle's service manual or a repair guide is recommended.
The thermostat on a 2004 Eddie Bauer Edition Explorer 4.6L V8 is located in the top heater hose. It is in the end that is attached to the water pump.
The powertrain control module (PCM) is mounted through the firewall on the passenger side. You can see one end of it with the wiring harness from the engine compartment , and the rest of the PCM is "hidden" inside the Explorer behind the glove compartment . Helpfull
I found on ford's web that it's inside the firewall on the drivers side. I haven't been able to locate it still though.
The Eddie Bauer is one trim level above the XLT Explorer
In the 2004 Ford Explorer Eddie Bauer, the Powertrain Control Module (PCM) is typically located in the engine compartment. Specifically, it can be found mounted on the driver's side fender well, near the battery. Accessing it may require removing some components for better visibility. Always consult a repair manual for precise instructions if you're planning to work on it.
I believe that is located below the battery tray