0
its a small square plastic knob located on the bottom passenger side corner of the radiator, slightly behind a few hoses, it drains through a small tube out the bottom of the car
i have a 94 but it should be same :)
Wiki User
∙ 14y ago
Add your answer:
Earn +20 pts
Where is the coolant drain plug on an 1995 Eagle Talon ESI?
its at the bottem of the rad
Is a 145000 miles to much for a 1995 eagle vision sedan?
No
Where is the coolant sensor on a 1995 Eagle Talon ESI?
Look right underneath the coolant hose where the radiator cap is. It should be located there.
Where is the flasher located on a 1995 eagle vision tsi?
It is located above the brake pedal.
How do you do a radiator flush on a 1995 Saturn?
The radiator on a 1995 Saturn is flushed by draining the coolant, refilling the engine with water, and adding a flush. It is allowed to circulate and drain before refilling with coolant.
How do you drain the coolant out of a 1995 Chevy Cavalier?
There should be a drain valve on the radiator on the bottom passengers side If not just undo the bottom radiator hose.
How do you drain the coolant on a 1995 Grand Am 4 cylinder 2.3 liter?
Look for the radiator drain it should be on the side of the radiator facing the engine next to the fan.
Why Rear end shake in a 1995 eagle vision?
If when applying the brakes ,roorts. If when driving only a bad tire.
How do you disable the alarm on a 1995 eagle vision?
Short VTSS Disarm Sense to ground, on the Body Control Module.
Where is the coolant drain cock on a 1995 Toyota Camry?
Should be either at the bottom of radiator or at the rear lower section of radiator
How do you flush the coolant system in a 1995 corvette?
Remove the bottom hose from your 1995 Chevy Corvette radiator. Allow the coolant to drain out. Put a hose into the top of the radiator. Run water through the radiator until it runs clear.
Where is the radiator drain plug for a 1995 Toyota 4 runner?
The 1995 four runner radiator drain plug is at the passenger side of the radiator at the bottom. It is a petcock, so you only need to loosen it until the coolant starts to flow.
