0
Where is the coolant temp sensor located on a 2001 Audi a6 2.7t?
Wiki User
∙ 14y agoWant this question answered?
Be notified when an answer is posted
Add your answer:
Earn +20 pts
Where is the coolant temp sensor located 0n a 1992 Audi CS 100 v6?
The temp sensor switch is located on the right side of radiator ,at the bottom.
Where is the crankshaft position sensor located on a 2002 Audi tt?
Where is the crankshaft position sensor located on Audi 2002 Audi TT
Where is the crank shaft sensor located in a Audi a4?
Where is the crank shaft sensor located in a Audi a6
Where is the coolant temperature sensor on a 2004 Audi a4 located?
See this link http://www.a4mods.com/index.php?page=webcontent/pages/ECTsensor.html
Where is the coolant temp sensor on an 1999 Audi a6 quattro 2.8?
how do i diagnose a heat problem in a 1999 audi quatro
Replace front abs sensor on a 2001 Audi a4?
Where is the answer
Where is the engine coolant temperature sensor in a 1997 Audi A6 Quattro and how do I replace it?
If It is the temp. sensor and not the thermosat I believe it is the bottom of the coolant tank. I thimk you have to buy a new tank.
Where the camshaft position sensor is located on a 1999 Audi a6?
where is bank 2 camshaft located audi a6 2.8 1999
Where is the camshaft sensor located on the engine for a 2001 Audi a4 quattro 2.8?
Left rear head and right front head. Has one on each side.
Where is the coolant temp sensor on an 97 Audi 2.8L V6 A4?
beetween the trhotle and air filter housing
Where is the engine coolant temperature sensor in a 1999 Audi A4 1.6L and how to replace it?
You should have gotten a letter from Audi about an extended warranty. The sensor is now covered for 10 years/100,000 miles for a falty sensor. This sensor (if malfunctioning) will cause the MIL to light up by "sensing" that the engine coolant is a couple degrees above what it should read. No Idea where it is but you shouldn't have to worry about replacing it yourself.
How to change the Coolant temp sensor location on Audi a6 1998?
ITS LOCATED AT THE BACK OF TH MOTOR ON PASSENGER SIDE. DISCONNECT PLUG. PULL PLATSIC CLIP OUT ( IT SLIDES IN TO LOCK SENSOR ) REMOVE SENSOR . THATS IT . wHEN REPLACING SENSR MAKE SURE YOU HAVE NEW O RING
