0
What else can I help you with?
Where is the of the temperature gauge sending unit on 93 Mazda mx3?
There is a coolant temperature sensor and a temperature gauge sensor. the coolant sensor is located on driver side of the cylinder head. screws right into it, and the temperature gauge sensor is on the front side of the cylinder head right under the distributor. hope this helps
Where is the IAT sensor of Mazda mx3?
it is located on the mass air flow censor on the intake. it is connected right on the out side of it.It has 5 wires running to it.
Where is the intake air temperature sensor on 1995 Mazda mx3?
In mass air flow sensor.
What is the most likely cause of coolant leaking from right rear of engine near firewall in 1993 Mazda mx3?
heater core leaking
Head gasket bolt torque specs for a Mazda mx3?
What are the head bolt torque specs for a mazda mx3 1600
When was the Mazda MX3 first produced?
The Mazda MX3 was first produced in 1991. It was introduced at the Geneva Motor Show in March of 1991. The MX3 was produced until 1998, when production was halted.
How do you replace fan belt on 1994 Mazda mx3?
well...there is no fan belt on any model of mx3, its using an electrical fan, and if you have A/C it has a second electrical fan just beside it. If its not working, it could be the relay, the motor, or the coolant sensor
Will a 1994 Mazda mx3 dash fit in a 1992 Mazda mx3?
yes, you will have to remove all the plastics from the 94 and put them into the 92, as well as the wiring.
How do you drain coolant 93 Mazda mx3?
i know on my 95 theres a simple drain plug built in to the radiator on the bottom on the pass. side. I think its a plastic 10 mm bolt.
How do you set timing on a 1995 Mazda MX3?
This is done the same as the 1995 Mazda MX6. The answer is posted.
How do you change the thermostat on a 1993 Mazda mx3?
waste of time
How do change brake pads on Mazda mx3?
well i just changed the brakes on my Mazda mx3 what you do is take the 2 pins out of the calipers which is holding the pads in place and then you are able to remove the pads
