== ==
The 1997 Ford Explorer ambient temperature sensor can be found on the bottom of the drivers side mirror. The engine coolant temperature sensor can be found on the front of the engine.
engine coolant temperature sensor is faulty. engine coolant temperature sensor is faulty. engine coolant temperature sensor is faulty. engine coolant temperature sensor is faulty. engine coolant temperature sensor is faulty.
The engine coolant temperature sensor is usually on the front of the engine. The coolant temperature sensor will be in the vicinity of the thermostat housing.
wher is the engine temperature coolant sensor BUICK 2001
The temperature sensor for the coolant system is located on the front of the engine. The exact location of the coolant temperature sensor is dependent upon the year of the engine.
Your engine coolant temperature gauge has a sensor ( there is also a engine coolant temperature sensor that is used for the computer / PCM )
On a 2003 Ford Explorer Sport Trac, the temperature coolant sensor is typically located near the thermostat housing, which is situated on the engine block. It can be found on the driver's side of the engine, usually towards the rear, and is inserted into the engine coolant passage. To access it, you may need to remove some components or hoses for better visibility and reach.
Coolant temperature sensor is located on the front of the engine. The coolant temperature sensor is a few inches above the thermostat housing.
The 2003 Mazda engine coolant temperature sensor is located on the front of the engine, above the thermostat housing. The sensor will have to wires leading to it.
Likely a faulty coolant temperature sensor. Change the sensor.
The engine coolant temperature sensor and coolant temperature sensor are the same.
To change the coolant temperature sensor on a 2002 Ford Explorer Sport Trac 4.0, first, ensure the engine is cool and disconnect the negative battery cable. Locate the coolant temperature sensor on the engine, usually near the thermostat housing. Disconnect the electrical connector and remove the sensor using a wrench. Install the new sensor, reconnect the electrical connector, and reattach the battery cable.