0
at the back of the motor on drivers side
Wiki User
∙ 14y ago
Add your answer:
Earn +20 pts
Where is the crank sensor located on a 1998 Mitsubishi 3000 gt?
there is no crank sensor on a Mitsubishi 3000 gt but there is a crank angle sensor that looks just like a distributor its in the back of the engine on top between valve covers
Where is the crank sensor located on 1998 Bravada?
the crank sensor is located just behind the crank shaft pully of the engine.
Is the crank sensor the same as the cam sensor on a 1998 ford escort wagon?
No
What would cause a 1998 Cherokee to stall while driving and not start not even push starting it?
Check the crank angle sensor usually about $150 to replace
What does a crank shaft sensor do on a 1998 Honda accord?
A crank shaft position sensor on a 1998 Honda Accord reads whether or not a the engine is spinning correctly. If there is a discrepancy on how the crankshaft is spinning the sensor will relay it to the ECU.
If the crank position sensor 1998 Dodge Dakota magnun v6 is not work what would happen?
If the crank sensor is not working, the engine will not run.
What controls the spark on a 1998 Chevy s-10?
Crank sensor.
Where is the crank shaft sensor on a 1998 BMW 740il?
The crank shaft sensor on a 1998 BMW 74Oil is located down near the crank on the front of a motor. It is super easy to replace but sometimes reaching the harness wire is a little bit difficult.
Why wont your 1998 Jeep Wrangler start?
Can be a number of things....but start with crank angle sensor located rear of engine above bell housing asuming it's a 4L six.
What happens when the crank sensor or cam position sensor goes out in a 1998 Chevy Malibu?
crank sensor will cause car to no start cam sensor will only set check engine light kbutlrtech@yahoo.com
Where is the crank shaft sensor on a 1998 cavalier?
Its on the backside of the engine, on the firewall side
Why does your 1998 Chrysler sebring jxi 2.5 v6 have no spark?
Check the crank angle position sensor. It is located on the left side (drivers), at the crank shaft. There is one fastener and an electrical plug to remove the sensor. I found it was easier to get off and back on by removing left front wheel and going through the wheel well.
