Want this question answered?
Behind the crank pulley
could be the crank sensor, the go out. the have a reputation for that.
if it has a crankshaft sensor that's bad
Yes
behind the crank shaft pulley. remove pulley and install new one make sure to replace it in the exact same spot it was before of you will tear up your new sensor
it should be behind the Harmonic Blance,right top
Behind the crank pulley that your belt rides on!
It's just behind the harmonic balancer.
The sensor is located in between the crank pulley and front cover, just to the lft of the crankshaft. In order to change the sensor, you must, first, remove the crank pulley. With the damper off, unplug the sensor, and pull off the plastic cover. The sensor is mounted with 2 bolts, just to the left of the crankshaft. You'll need a deep 15mm socket.
THE CRANK SENSOR IS LOCATED ON THE PASSINGER SIDE OF THE ENGINE , BUT ON THE BACK OF THE ENGINE YOU MMUST REMOVE THE FRONT TIRE TO REACH IT RIGHT BEYOND THE SPEED SENSOR No it's not! It is located between the transmission and the engine block above the oil pan on the rear(since the engine is sideways)just about the middle of the car. It has one bolt holding it in and it is a little hard to get out, careful not to break the bolt
behind the crank pulley
IS CALL CAMSHAFT SENSOR AND IS LOCATED ON THE RIGTH SIDE OF THE ENGINE , ABOVE THE CRANK PULLEY You will have a crank sensor, but it won't have a cam sensor. it dose have a cam sensor, on the timing cover left sind of water pump