0
There is no crank sensor on a 1986 camaro z28.. that sensor is in the camaros past 1988 i believe.. but the 1986 carb or fuel injection (tpi) does not have one
Wiki User
∙ 16y ago
Add your answer:
Earn +20 pts
Where is crankshaft positioning sensor located on 1986 ford van?
A 1986 ford van does not a crank shaft position sensor,, it uses the pickup in the distributer
Fuel pump relay location on a 1986 Chevy camaro z28?
Check
Does a 1986 Chevy Camaro have o2 sensors?
Yes. It has an O2 sensor on the exhaust y-pipe.
How do you test a Crankshaft Sensor in a 1986 Nissan 300ZX?
Using a scanner with a scope, you can view the output wave of the sensor as you crank the engine.
Where is the coolant temperature sensor on a 1986 Camaro Z28?
side of the head on the drivers side, close the exhaust mainifold
Were is cam sensor on 1986 s-10?
A cam sensor and crank sensor was not used on that year. If the engine is not firing then I would replace the ignition module that's in the distributor.
Where is the fuse box on 1986 Chevy Camaro Z28?
where is the fuse box in a 1986 camaro
Where is the Crankshaft Position Sensor located on a 1986 Fiero?
V6 crank position sensorThe crank position sensor is part of the distributor on a V6 All Fieros equipped with a distributor (1984 - 1986 4-cyl and 1985 to 1988 V6) have the crank sensor inside the distributor. It may also be known as a distributor pickup or HEI pickup.Fieros with DIS (1987 to 1988 4 cylinder) have a crank sensor on the back side (engine side) of the ignition module extending into the engine block. The ignition module is the flat base that the ignition coils are attached to.
Where is fuel pump reset switch on a 1986 Camaro?
Where is fuel pump reset switch on a 1986 camaro?
Where is the 02 sensor on a 1986 2.8L v6 camaro?
i know of two on on the header pipes just before the catalytic converter i can't remember if there are more
Does a 1986 camaro have a governor?
no.
On an 1986 range rover 3.5l v8 efi where does the crank signal come from?
i dont understand your question. but if you want to know if there is a crank sensor or something the anwer is no. since your car is an old model and it has distrubutor.
