Crankshaft Sensors
1982-1994 Chevy Cavaliers
1995-2005 Chevy Cavaliers

Where is the crank shaft sensor located in a 1990 Chevy Cavalier?

252627

Top Answer
User Avatar
Wiki User
2004-12-29 06:07:52
2004-12-29 06:07:52

It is located on the back side of the engine, where the distributor originally went.

1
๐Ÿ™
0
๐Ÿคจ
0
๐Ÿ˜ฎ
0
๐Ÿ˜‚
0

Related Questions

User Avatar

where is the crank sensor located on a 2005 chevy impala

User Avatar

The crankshaft position sensor is located behind the starter on the front of the engine. Hope this helps! Mitch art_y2k1@yahoo.com

User Avatar

it is next to the coils at the rear of the engin between the tranmission and the engin

User Avatar

Problem with the signal from the Crank Sensor.

User Avatar

The crank sensor is located on the back engine wall in the middle, just under the two coil packs (from where the spark plug wires come). There is a wire harness from the crank sensor to the module which holds the two coil pack. The crank sensor is held into the engine by a single bolt. To see all of this, you have to go under the car. I am having an intermittent no start problem with my 93 Cavalier (it cranks, but no spark at all) and I think the crank sensor is my problem.

User Avatar

That year model did not use are have a crank sensor.

User Avatar

Where is the crankshaft sensor located on a Chevy 1500 sil. turbo diesel truck?

User Avatar

That year did not have a crank sensor on it.

User Avatar

THE CRANK SENSOR ON A 97 5.7 IS LOCATED UNDER THE CRANKSHAFT PULLEY BETWEEN THE PULLEY AND THE OILPAN. SLIGHTLY TO DRIVERS SIDE

User Avatar

On the firewall side of the engine block, near the transmission bellhousing, under the intake manifold that answer sir, is incorrect, the cavaliers did not use a cam sensor, only a crank sensor, but the location is right for the crank sensor

User Avatar

The 1997 Chevrolet Malibu crank position sensor is located on the back of the crankshaft. The rear engine cover will need to be removed in order to view the sensor.

User Avatar

Located behind the starter. Have to take starter off to get to it.

User Avatar

To test a 1995 Cavalier crank sensor you would need to get a mechanic's computer. They can put a sensor/fuse tester on it and see if it is working properly.

User Avatar

Chevy did not use a crank sensor on that year.

User Avatar

it is behind the starter. You will have to remove the starter to get to it.

User Avatar

A crank sensor was not USED on a 1995 model.

User Avatar

where is the crank shaft pistion sensor located on a 2002 Chevy Malibu, and how hard is it to replace

User Avatar

the crank sensor is located just behind the crank shaft pully of the engine.

User Avatar

Where is the crank sensor on a 95 chevy lumina car ?


Copyright ยฉ 2020 Multiply Media, LLC. All Rights Reserved. The material on this site can not be reproduced, distributed, transmitted, cached or otherwise used, except with prior written permission of Multiply.