0
What else can I help you with?
Where is the crank sensor located on a 1994 Oldsmobile achieva?
On a 1994 Oldsmobile Achieva, the crankshaft position sensor is typically located near the crankshaft pulley, mounted on the engine block. It is positioned at the front of the engine, often near the transmission bell housing. To access it, you may need to remove some components, such as the air intake or other parts obstructing the sensor. Always consult the vehicle's service manual for specific details and diagrams.
Where is the crankshaft sensor located on a 1988 Oldsmobile cutlass supreme?
where is the crankshaft sensor located on a 1988 cutlass supreme
How to locate and replace crankshaft sensor on 1996 Oldsmobile Achieva 2.4 liter engine?
did u ever figure it out?
Where is the crank shaft sensor on a 1995 Oldsmobile Achieva 4 cylinder?
well on the 6 cylinder, it is behind the crankshaft pully, try there.
Where is the Camshaft Position Sensor located in the 1996 Oldsmobile Achieva?
The Camshaft Position Sensor is located behind the Power Steering Pump.
1989 Oldsmobile delta 88 crankshaft sensor location?
The Crankshaft sensor is located behind the Harmonic Balancer on the front-passenger side
Where is the crankshaft position sensor located on a 1999 Oldsmobile Intrigue and how is it replaced?
The crankshaft sensor is in the front of the engine.Above the starter.You will have to drop the starter.2 15mm bolts.Look up and there it will be.
How do you replace a crank sensor for a 1997 Oldsmobile achieva 6 cylinder?
To replace the crank sensor on a 1997 Oldsmobile Achieva with a 6-cylinder engine, first, disconnect the negative battery cable to ensure safety. Locate the crankshaft position sensor, which is typically found near the crankshaft pulley or on the engine block. Remove any necessary components for better access, then unbolt and disconnect the old sensor from its wiring harness. Install the new sensor by reversing the steps, ensuring it is securely fastened and reconnected, and finally reconnect the battery cable.
Where is the o2 sensor on an 1998 Oldsmobile Achieva?
the O2 Sensor Should be on top of your exhaust manifold
Where do you find the oil sensor on a 1992 Oldsmobile Achieva?
Plug has 3 wires.
Where is the crankshaft position sensor located on a 1994 Olds Achieva Quad 4 23L?
You will fine it right on side of the starter on the front side of the motor
Where is Rear crankshaft sensor located on an Oldsmobile Silhouette?
if it has a 3.1 or 3.4 it is located between the engine and the trans just above the oil pan.
