Don't know the vehicle in detail but the sensor can only be either round or next to the front crankshaft pulley or on round the flywheel, perhaps on the bell housing? the crankshaft sensor for a Jeep 2000 is located behind the starter you have to remove the starter to replace it Tommy :-)
It does not have a mass airflow sensor.
There is no such sensor, the oil change reminder only runs off of mileage on a 2004
The 2004 Jeep Grand-Cherokee has 12 valves.
The maximum payload of the 2004 Jeep Grand-Cherokee is 1100 lbs..
The 2004 Jeep Grand-Cherokee has a drag coefficient of .45 Cd.
It is behind the starter.
Location of crank shaft position sensor of a Nissan altima 2.5 2004? send diagram please
The crank shaft position sensor is just above the oil filter at the tail end of the starter
It is bolted in the side of the block BEHIND the starter. You will have to REMOVE the starter.
bottom front on passanger side behind a/c compressor.
It is on the bottom left side of the timing cover, behind the balancer.
hi i have a 2004 mitsubishi l200 ediesel that wont start,turns over but not firing,been told its the crank shaft position sensor
Back of the block, about two inches above oil pan.
It is under the timing belt cover near the crankshaft pully / harmonic balancer.
where is the crank position sensor located on a 2004 hyundai v-6 2.7 engine
How_do_you_replace_a_crank_sensor_on_a_2004_jetta
The crank sensor is located under the car near the exhuast. If you have the replacement you'll see it easy.