Remove the thumbscrews which attach the headlight and turn / running lights. Both have to be removed to access the daytime running light bulb.Type your answer here...
where is the running light sensor on a 2003 grand marque
Where is the module light day on Mazda tribute 2003 4 cylindre
You need to replace the DRL (Daytime running light) Module
top left side of dash board, two relays
2003 GMC Yukon daytime running light (DRL) bulb replacement: Purchase the correct replacement daytime running light (DRL) bulb(s) first, before disassembling the vehicle. See sources and related links below for replacement bulb information. Then consult your owner's manual for the daytime running light (DRL) bulb replacement procedure. As simple as it sounds, the owner's manual is the best place to start for bulb replacement instructions and illustrations. You may want to consider replacing both left and right at the same time in order to keep brightness and color equal (optional).
DRL - Daytime Running Light (relay). Found over the top of brake pedal area under dash. Used in conjunction with Automatic light Control Sensor, head lights, fog lights, and control switches to control light operations. Your automatic lights and Daytime Running Lights are controlled by this module.
2003 Lexus RX300 daytime running light (DRL) bulb replacement: Purchase the correct replacement daytime running light (DRL) bulb(s) first, before disassembling the vehicle. See sources and related links below for replacement bulb information. Then consult your owner's manual for the daytime running light (DRL) bulb replacement procedure. As simple as it sounds, the owner's manual is the best place to start for bulb replacement instructions and illustrations. You may want to consider replacing both left and right at the same time in order to keep brightness and color equal (optional).
there is a number of things that could cause this. here are a few easy ones to check. is the e-brake fully disengaged. are the bulbs burnt out. is the wiring harness plugged into the daytime lights bulbs and in good condition. if these check out, you may have a fault in the daytime running light module.
If the Explorer is running engaging the parking brake is supposed to turn the daytime running lights off , otherwise the daytime running lights are supposed to shut off when the engine is shut off . I have a 2004, Eddie Bauer Explorer. On the light switch itself, there is a selection to turn on or off the day lights, as well as the extended, courtesy lights after ignition is turned off.
Bad switch, bad daytime running light module wiring issue
I have a 2003 Yukon and looked at how to replace the daytime running lamps for about 6 months until I found that the rubber sheet behind the lamp socket had a slit in it. you just have to find this slit from the engin compartment / cooling shroud area and reach through to the socket. Good luck I hope this hasn't worried you for as long as it did me. Jack