Best Answer

It's on the fuse block under the dash with the rest of the fuses it should be relay numbered 109 in big white letters

User Avatar

Wiki User

โˆ™ 2009-07-10 01:43:00
This answer is:
User Avatar
Study guides
See all Study Guides
Create a Study Guide

Add your answer:

Earn +20 pts
Q: Where is the ecm relay on a 1996 volkswagen jetta?
Write your answer...
Related questions

Where is the radiator fan relay on a Volkswagen jetta?

The Volkswagen Jetta uses an ECM instead of a stand alone fan relay. The ECM has to be changes as a single unit.

What is the 428 relay do on 2000 jetta 1.8t?

Relay #428 under the hood is the ECM Power Control Relay.

Where is the oxygen sensor relay located in 1996 Audi a-4?

There isn't one, its wired into the ECM.

Were is the ecm relay located on a 1991 s10?

The ecm module is located behind the passenger side kick panel. I don't know of an ecm relay.

How do you set the time on a 2004 VW Jetta?

There is no timing set for a 2004 jetta, the timing is automatically set by the ECM.

Where is the location ecm on a 1996 Nissan maxima?

were is the location ecm on a 1996 Nissan maxima

Why no voltage to Crank sensor in jaguar xj6?

Bad ECM or ECM relay.

Where is the fuel pump fuse for a 1996 Ford F-250?

The fuel pump works through the fuel pump relay which in turn works through the ECM relay. This does not answer the question of where these relays are and wich ones they are.

Fuel pump relay on 1988 Mazda 323?

not sure of your question, but, the relay is mounted under or behind the engine computer or ecm.. you have to remove the ecm to find the relay. It is on the inside of the firewall in the middle behind the radio. Good luck

How do you remove speed governor on Jetta GLI?

It's programmed into the engine ECM. You need to either replace the ECM, or have the existing one reflashed with new parameters.

Where is the ECM located on a 2000 VW Jetta?

ECM is located on drivers side, below the base of the windshield underneath the plenum. You have to remove plenum panel for access.

How do you remove a engine governor jetta?

its in your ecm ecu the computer in the jetta stops it from reachin maximum speed also if your gonna do it get preformNCE TIRED THE BEST THING TO DO IS GET IT TUNED

How do you reset the Ecm or computer on a 95 jetta gls w 2 liter engine?

If the check engine light is on... you might have an open circuit somewhere. Pre-1996 vehicles are not as easy to plug in and read as the OBDII cars.

Where does the fuel pump relay get its power from?

i do believe it is the ecm/computer

Where is the ecm on a 1996 Toyota land cruiser?

location of the ecm on the Toyota land cruiser 93

Where is ecm located on 1999 Honda Accord?

The ECM on a 1999 Honda Accord is located under the hood. It is in front of the fuse and relay box.

Where is fuel pump relay located in a 92 Mercury Capri?

The fuel pump relay is locate under the ECM. "Computer"

Where is the fuel pump relay ground on a 1991 jeep wrangler yj?

The fuel pump relay is grounded through the ECM.

On a buick 1992 park avenue what supplies power to the fuel pump relay?

The ECM powers the fuel pump relay

Where is ECM location on 2004 Altima?

On the 2004 Altima, the ECM is located under the hood. It is located around the under-hood relay and fuse box.

Will a 1996 firebird ecm work in a 1992 sunbird ecm?

1992 sunbird is obd1,1996 firebird is obd2.Will not work.

Where is the ecm relay for a 1989 mustang?

it should be on the passenger side kicker panel right above the computer. I just pulled my relay out to replace and everyone says that is for the ecm. electronic control module aka computer, or powertrain control module.

Where is the fan speed relay on a 1991 dodge dynasty?

It is inside the ECM Module

Can the computer be malfunctioning causing vehicle to not start?

Yes, The ecm sends a ground to the starter relay which in turns sends current (power) to the starter relay or moving pole shoe, however yours is equipped. The ecm receives a signal from the transmission position sensor so that the ecm knows whether the vehicle is in neutral or park. Thus only sending ground to relay when the proper shift position is attained.

Does the ECM on a 1996 Pontiac Grand Am have anything to do with the AC?