answersLogoWhite

0

Where is the ecu fuse in a 1998 gmc jimmy 4x4?

Updated: 8/20/2019
User Avatar

Wiki User

12y ago

Want this question answered?

Be notified when an answer is posted

Add your answer:

Earn +20 pts
Q: Where is the ecu fuse in a 1998 gmc jimmy 4x4?
Write your answer...
Submit
Still have questions?
magnify glass
imp
Related questions

Where is the ecu fuse on a Renault clio?

Ecu fuse where is on the renault clio


Where is ecu fuse on 2003 Tahoe?

Where is the ecu fuse on a 2003 Tahoe


What is ecu-ig fuse?

An ECU-IG fuse is a fuse directly made for a Toyota automobile. It is mainly used for the electronic anti-lock brake function.


Where is the fuse for the diagnostic terminal?

There is not one. The is an ECU fuse.


What does a ECU fuse do?

AnswerThat is Electronic Control Unit, the computer. If you blow or remove the ECU fuse the car will not run.


Why does ecu fuse keep blowing on a 1995 Nissan skyline R33?

To small a fuse for the circuit, short in the wiring, or defective ECU.


Where is the ecu on a 2500 4x4 Cummins?

It is on the driver side of the engine block.


Where is the ecu fuse on a vauxhall zafira 1.6 year 2000?

The ECU fuse on a 2000 Vauxhall Zafira 1.6 is located in the power distribution box. It is a 20 amp fuse.


How do you reset the ecu in a 94 Honda civic?

Disconnect the battery for 60 seconds, if that does not work remove the ECU fuse and the backup fuse for a minute.


Where is the radio back in fuse located In a 1999 Dodge minivan?

ECU fuse


How do you reset ecu on vs commodore?

Reset ECU VS V6 Commodore · 1 Open the fuse panel in the driver-side foot well, under the steering column, by pulling down on it with your fingers. · 2 Locate the fuse for the ECU using the fuse diagram on the underside of the fuse panel cover. 10Amp · 3 Pull the fuse for the ECU using the fuse pullers in the fuse panel. · 4 Turn the ignition to the "On" position but don't crank the engine (it won't start anyway). · 5 Wait five minutes and reinsert the fuse. The "Check Engine" light will blink, then shut off. This will indicate that your ECU has been reset.


What would cause the ECU fuse to keep blowing on a 1998 Chevy S-10?

It could be a ground problem. It could be a short in one of the sensors. It could be the ECU itself is bad and needs replacement. Computer issues are not as uncommon as we'd like them to be.