IF it's a small block- V-8 there are 2 plugs, one on each side of the motor beneath the Exaust manifolds-ABOUT in the middle of the motor & usally take a 9/16 inch socket 2 remove them-I install NEW petcocks instead of the plugs so as not to need sockets the next time-IF U are going 2 drain on a regular basis.
The 2002 Tacoma engine block will have two coolant drain plugs on each side of the block. The coolant drain plugs will be near the front and the rear of the engine block.
it is on either side just behind motor mounts
The coolant drain plug on a Nissan Micra engine block is on the upper part of the block. It is under the intake manifold.
Open the drain valve on the side of the engine block.
where is the coolant drain plug on the engine block of Honda ACCORD 2.4 2006
You drain coolant from the radiator. but according to the book ther are two plugs on the engine block that need to drain the coolant from.
The 1994 Lincoln Town Car 4.6 liter engine coolant drain plugs can be found on each side of the engine block. There will be a total of four engine coolant drain plugs.
Most vehicles have a drain on both.
The coolant drain plug is located on bottom corner of radiator facing engine.
The engine block coolant drain plug on 4.3 liter Chevy Blazer is located on the bottom of the engine, near the oil filter. It allows coolant to be completely drained from the block during maintenance.
in the block...
on the buttom of the block Can you please be more specific? Where exactly on the bottom of the block? Near what on the block?
There should not be a coolant drain on the engine block. You are probably looking at a freeze plug which should NOT be removed. The freeze plugs where openings for the original production/casting of the engine block and are sealed.
Wear is drain plug on 1997 GMC 7.4
Ive never heard of draining coolant plugs except on a diesel engine . Once you drain the coolant and flush the system it should be fine
Rear of the engine block, near the oil pan.
its at the bac of the engine under the cooler cables
You will have to drain part of the coolant. Try to drain as little as possible and fill up before restarting the engine. No, the thermostat is usually at the top of the engine block (placed between the top input hose and the block). If, however, the radiator is full of coolant, there will be some spillage. Also, make sure the coolant has cooled down before replacement, and do periodically replace the coolant as needed.
Remove the oil pan drain plug to drain the oil. Remove the lower radiator hose to drain the coolant.
block heaters are kinda hard to install. you would have to drain your coolant and take out one of the freeze plugs. that's were the block heater gets put in to warm the coolant in the block.
We are gonna need to know which drain plug you are looking for, radiator coolant, engine block coolant, rear differential oil, front differential oil, engine oil,
On either side of the engine block. It will require a 6 point 13mm socket to remove it.
Right Rear of engine block. Above Alternator, Below coolant drain plug
Sometimes they use that threaded drain plug location to attach a knock sensor. So if you see a knock sensor threaded into the side of the block that may be where the coolant drain is located.
The engine block coolant drain plug on a 350 Chevy Tahoe is above the oil pan, mid engine on driver's side