It is an orifice tube and is located inside the joint/connection under the receiver/dryer.
center of valve cover at rear of motor
How do you change a Master Cylinder and hydraulic clutch line for a 1998 Chevy S10?
The egr valve is on the top of the engine in the front it is plugged into your wiring harness and has two bolts holding it on, it is shaped like a cylinder and is next to the water jacket on the engine.
The 1998 Cavalier does have a PCV valve. The valve is in the side of the valve cover, held in by a metal ring.
98 chevy lddle control valve
There is not one.
No, it does not.
The 1998 and newer S10 with the 2.2L engine does not have a serviceable pcv valve.
No pcv valve that can be serviced, the 1998 and later 2.2L OHV engines are equipped with an oil/air separator that is located inside the valve rocker arm cover that requires no maintenance. I have a 1998 Cavalier RS Coupe and I love it, also love my 2003 Mustang.
Four cylinder, on top of the valve cover. Six cylinder, it is built inside the distributor.Four cylinder, on top of the valve cover. Six cylinder, it is built inside the distributor.
Six cylinder, it is a non serviceable component of the distributor.Four cylinder, it is on top of the valve cover.Six cylinder, it is a non serviceable component of the distributor.Four cylinder, it is on top of the valve cover.
The ERG valve is located on the front of the engine on a 1998 Chevy Blazer V6 4.3L. It is near the top bolted to the intake manifold.