0
The Fuel Cut Off switch is actually called the Fuel Inertia Switch and it is located on the passenger side floorboard near the hump underneath the carpet. Just pull the carpet back from the firewall and you will see it. To reset it pull the white tab up (or push down to shut off. But I don't recommend this because tampering with it too much will cause it to fail, and your truck will no longer start until its replaced.)
What else can I help you with?
Where is Fuel pump cut off switch for a ford bronco?
the switch you are looking for i beleave is the inertia switch.. on your bronco i beleave it is located behind the glove box
Where is the inertia switch located on a Full Size 1987 Ford Bronco with a 302 engine and automatic transmission?
driver side board about 8 inches above the dimmer switch
Where is the inertia switch located on the 1989 Ford Bronco?
On the interior firewall to the left of the steering column
Where is the fuel intertia switch on a 1985 Ford Bronco?
its located on the passager side of the truck under the dash
Where is the fuel cut off switch located on a 1988 ford bronco?
under the dash,,drivers side
Where is the act sensor located at on a 1989 ford bronco II?
emissionswhere is the air charge temp located for a 1987 ford crown Victoria 5.ol
What is the difference in Ford Bronco and Bronco Eddie Bauer?
The Eddie Bauer was an option ordered from Ford. It was the top of the line Ford Bronco from 1987 to 1996
Where is the neutral safety switch located on a 1992 ford bronco?
On a 1992 Ford Bronco, the neutral safety switch is typically located on the transmission, attached to the transmission case. It is positioned near the shift linkage and can be accessed from underneath the vehicle. The switch prevents the engine from starting unless the transmission is in either the "Park" or "Neutral" position.
Where is fuel shut off switch for 1988 Ford Bronco Eddy Bauer?
where is fuel shut off switch for Ford Bronco eddy Bauer
Where is PCV valve located on 1987 Ford bronco?
The pcv is located on the passenger side of the motor, under the edge of the intake manifold, in the back.
Where is the high and low beam switch located at on a 1984 ford bronco?
84 should be mounted on the drivers side floor
Why does my 1987 ford bronco 2 idle for 5 to 10 seconds then die?
Check the TFI module. It is located on the distributor.
