answersLogoWhite
Fuel Filters

Where is the fuel filter in a 350 engine for a 1978 Chevy pickup?

353637

Top Answer
User Avatar
Wiki User
2004-12-19 19:54:15
2004-12-19 19:54:15

If it is a 350 with a four barell carburator, the fuel filter is a cartridge inline at the carb. Unscrew the large nut where the fuel line goes into the carb and the fuel filter is inside.

1

Related Questions

User Avatar

Yes, there is a nylon ``sock`` on bottom of fuel pickup.

User Avatar

1978 Chevrolet Big10 pickup

User Avatar

u have to pull the whole distributer to change the pickup coil

User Avatar

what is the firing order for 76 Chevy c10 pickup

User Avatar

Standing in front, looking at the engine, clockwise.

User Avatar

To repair a horn on the 1978 Chevy pickup, first check to make sure the wiring is correct. Then, remove the steering wheel cover in order to check to be sure the wiring is connected to the steering wheel.

User Avatar

350 4 Barrel is what is in mine

User Avatar

look in front of the gas tank along the frame on the drivers side.

User Avatar

As long as The Engine is The same that the trasmission was on before then yes it will work.

User Avatar

How do you change the heater core on a 1978 Chevy Nova Custom with a 305 v8 engine and where is it located on the car? thanks jj

User Avatar

Right front corner of the engine.Right front corner of the engine.

User Avatar

check your wiring to the motor, if you have a hot lead on it, figure out why.

User Avatar

Engine oil capacity in a 1978, 1979 and 1980 ford fiesta with the 1.6 kent engine is 3.2 quarts with filter and 2.8 quarts without pulling the filter.

User Avatar

On the Chevy V8 it is on the front of the engine driver's side. On a inline 6 cylinder it is the plug on the front of the engine. On the V6 it is the front plug on the passenger side.

User Avatar

I found the answer myself and for any of you looking for the same thing it can be found in a chiltons manual, found at most auto supply stores i got mine at o reillys.

User Avatar

Probably around 5000-5500 pounds. It should list it on the driver door.

User Avatar

if its a loud knock from the bottom end, DO NOT run the engine, it is likely a spun bearing; have a professional look at it

User Avatar

its not in the tank - on the front/side of the engine in the tank more than likely

User Avatar

advertised horsepower is...........165HP @ 3800 RPMs.

User Avatar

It should be in the back of the engine, just to the drivers side of the distributor.

User Avatar

There are several places to find cowl hoods,,,,LMC truck,,,harwood,goodhoods,and probably the cheapest ebay....


Copyright © 2020 Multiply Media, LLC. All Rights Reserved. The material on this site can not be reproduced, distributed, transmitted, cached or otherwise used, except with prior written permission of Multiply.