The oil filter on a 1990 Pontiac 6000 is located on the driver's side of the engine compartment. It is on the side of the motor all the way to the rear, near the firewall.
The fuel filter is located just in front of the drivers rear wheel underneath the car.
The fuel filter is just inside of the left rear wheel on this car.
On the oil pan there is a cap you unscrew, and inside there is a "card board filter", that you would pull out and replace.
To The Owner of the 1986 Pontiac 6000: I am the owner of two 1985 6000 STE's and my fuel filter is an inline filter on the right side of the car. It is about the size of a soda can. First, shut of power so when you remove the fuel filter, very little fuel will come spurting out. Next, after removing the old filter, plug in a new filter, then restore power. Most Sincerely, Kristopher Gerbracht email@example.com
It is next to the oil filter.
Should be at the bottom or rear of radiator
Yes, but only when you learn to write a coherent question.
In a 2.5L the handle end faces up.
have a pontiac 6000 2.5 motor and it wont stay running
It definitely sounds like a fuel problem, the first thing I would do is change the fuel filter .
On the distributor.
there will be 2 bolts on each side they are located behind the fender take them out and remove the clips from the top and bottom
In the glove box. You will see a cover that says fuses on it. On the back of the fuse panal door you will find a fuse puller tool. Good Luck!
Seats from any other GM A-bodies (Buick Century, Olds Cutlass Ciera and Pontiac 6000) should fit.
You could call your local auto parts store and they should know the answer to that one
There appears to be a large amount of information available for the Pontiac 6000 car. If one is wanting to view reviews these can be found on the Edmunds site as well as on Car Guru.
NO the dash doesn't have to be removed. There should be a panel under the dash that is black and have a bunch of 7 mm screws securing it to the firewall/other plastic.
The Bold and the Beautiful - 1987 1-6000 was released on: USA: 7 February 2011
Wiring diagram of what component?
2.5L 4cyl base. Iron Duke
Rear of the engine block (firewall side), below the center spark plug, just above the oil pan.
The weight of the Pontiac 6000 SE is recorded as being 3,021 pounds. This weight can be altered by aftermarket products which are installed on the vehicle or parts which may have been taken off of the vehicle since being manufactured.