0
Where is the fuel filter located on a 1997 Chrysler Sebring LXI 2.5L V6?
Wiki User
∙ 12y ago
The fuel filter is located above the rear of the fuel tank. You will need to drop the fuel tank down about 10 to 12 inches, as the fuel lines allow, and disconnect the three fuel lines. There is one that is connected to the fuel filter and two connected to the fuel module (pump). Be sure the fuel tank is almost empty before you try to lower it.
AnswerUnder the car in the fuel line.answer exactly.
quote from the Chrysler sebring manual
The fuel filter mounts to the frame above the rear of the fuel tank. The inlet and outlet tubes are permanently attached to the filter.
it is just forward of the rear cross-member that is between the rear wheels.
Wiki User
∙ 12y ago
Add your answer:
Earn +20 pts
Where is the cabin filter on a 1997 Chrysler Sebring?
A 1997 Sebring does not have a cabin filter.
Where is the fuel filter located on a 1997 Chrysler Sebring Convertible?
Above the gas tank
Is there a fuel reset on a 1997 Chrysler Sebring JXI If so where is it located?
A Chrysler Sebring does not have a reset switch.
How much oil do you put in a 1997 Chrysler sebring?
Five quarts with the filter.
How do you change a cabin air filter for a 1997 Chrysler Sebring?
It doesn't have one.
Where is crank sensor located on 97 sebring lxi?
where is the crank sensor located on my 1997 Chrysler sebring lxi
Where is the hydraulic pump for the 1997 Chrysler Sebring convertible located?
The Hydraulic pump for 1997 to 2006 Chrysler Sebring convertible is located behind the back seat and center of the car on a small shelf.
Will a 2001 Chrysler Sebring fender fit on a 1997 Chrysler Sebring?
No,No,
What are the symptoms of a bad thermostat on a 1997 Chrysler Sebring Lxi?
what are the symptoms of a bad thermostat on a 1997 Chrysler Sebring Lxi what are the symptoms of a bad thermostat on a 1997 Chrysler Sebring Lxi
Where is the starter located on a 1997 Chrysler Sebring Convertible JXI 2.5L 6 cylinder?
Look for you oil filter, it is right next to it, toward the driver side
Where is the Cmp located on a 1997 Chrysler Sebring 2.5?
It is an internal, non replaceable, part of the distributor.
Where does the 1997 Chrysler sebring knock sensor located?
The Chrysler Sebring knock sensor is located in the engine valve or cylinder located at the back of the motor. This part is in this position next to the engine valve so the sensor can feel the vibration of the engine.
