It is located inside the gas tank.
It is located inside the gas tank.
To remove the fuel pump from a 2003 Cadillac Seville, first, relieve the fuel system pressure by removing the fuel pump relay and running the engine until it stalls. Disconnect the negative battery cable, then access the fuel pump by removing the rear seat cushion and the fuel pump access cover. Detach the fuel lines and electrical connector from the pump, then unscrew and remove the pump assembly from the tank. Finally, replace the pump and reassemble all components in the reverse order.
If you are looking for a reset switch, GM vehicles do not have them. The fuel system is computer controlled with replays.
Drop the fuel tank. Its in the tank
The fuel pump pressure for a 2003 Cadillac Seville typically ranges from 40 to 50 psi (pounds per square inch) when the engine is running. This pressure is crucial for the proper functioning of the fuel injection system. If the pressure is outside this range, it could indicate a problem with the fuel pump, fuel filter, or fuel pressure regulator. Always refer to the vehicle's service manual for specific diagnostic and repair procedures.
well i dont know
Inside the fuel tank.Inside the fuel tank.
it is located in the gas tank
How do you replace the water pump on a 1988 Cadillac Seville?
The 1987 Cadillac fuel pump relay switch is located in the fuse box. The fuel pump relay switch will be at the top of the third column.
When you are having mechanical problems with your 2003 CTS Cadillac, you will know that your fuel pump is going out.
Check for a clogged fuel filter, is the fuel pump working? Did someone trip the fuel relay switch which cuts off current to the fuel pump?