answersLogoWhite

0

In the fuse box, under the hood, behind the battery. It will be a green relay.

Maybe this will help :

http://mysree.wordpress.com/2007/12/11/fuse-diagrams-and-specs-for-1994-Ford-probe-gt-v6/

User Avatar

Wiki User

17y ago

What else can I help you with?

Related Questions

Where is the AC relay located on a 1993 Ford Probe?

In the main fuse box under the hood behind the battery


Dia gram of starter location 1993 ford probe?

diagram of starter in a 1993 ford probe


Where is the crankshaft position sensor on a 96 Ford Probe SE?

"Where is the crankshaft position sensor on a 96 ford probe SE?"


Where is the fuel pump relay located on a 1996 ford probe?

In the fuse panel in the engine compartment Relay # 21 is the fuel pump relay on a 1996 Ford Probe ( Helpfull )


Where is location of fuel pump relay on a 1993 Ford Probe?

if you look under the hood in the main fuse panel. you will see a green relay marked circuit relay. that's the one you are looking for.


Where is the fuel pump relay on a 1993 Ford Probe?

I had a hard time finding this relay also. I went to the Ford Dealer and looked it up in the service manual. The fuel pump relay is the one in fuse box by the battery; the relay is located top right(green nf02) listed on cover as circuit relay.


94 Ford Probe 4 cylinder stalls at idle Replaced MAF sensor fuel pump fuel filter fuel pump relay Why is it still stalling?

Because it's a Ford.


Factory rim width on 1993 Ford Probe gt?

ford probe gt rims are 7 inch


Where do you locate the fuel pump on a 93 Ford Probe?

Were do I locate the fuel filter on a 1993 Ford probe 4 cylinder


Will rims from a 1993 Ford Probe fit a 1996 Ford Mustang?

Not directly, no.


What engine is in Ford Probe?

its a Mazda engine . ( DOHC 4cyl. 16 valve 2.0l ) For the probe 1993


Is a 1993 Mazda mx6 speed sensor work in 1994 ford probe?

While the 1993 Mazda MX-6 and the 1994 Ford Probe share similar platforms and components due to their shared development by Mazda and Ford, compatibility of the speed sensor can vary. It's recommended to check specific part numbers and compatibility guides, as there can be differences in electrical connections or design. If the part numbers match, it's likely that the speed sensor will work; otherwise, it's best to consult with a mechanic or parts specialist.