Cars & Vehicles

Where is the iat sensor located in 300 zx non turbo 1987?

123

Top Answer
User Avatar
Wiki User
Answered
2012-02-13 01:53:35
2012-02-13 01:53:35

i can't find the iat sensor for my 1987 nissan 300zx non turbo

001
๐Ÿ™
0
๐Ÿคจ
0
๐Ÿ˜ฎ
0
๐Ÿ˜‚
0

Related Questions


15 degrees BTDC for turbo and 20 degrees BTDC on non-turbo...

The engine coolant temperature sensor is located at the timing belt end of the engine on the water outlet casting.

I'm not positive from personal knowledge but my buddy who is helping me work on my 87 300 zx turbo he said that a 240 sx actually has the same trans ans the 300 so if both are n/a or both are turbo they should be interchangeable

Under the steering wheel, in the clockspring.

The 2001 Lexus coolant temperature sensor can be found on the front of the engine. The coolant temperature sensor will be in the vicinity of the thermostat housing.

Turbo 300, Turbo 350, Turbo 400 and 700R4 are the first ones that came to mind.

around 150 non turbo and about 211 for the turbo

It's located on the air intake hose right next to mass air flow meter

open the hood,it's on driver side near by brake master cylinder and intake manifold it's about a foot long aluminum canister undo the lid with number 13 wrench.

Passenger side of the bell housing, Just behind the engine.

They are always on exhaust manifold/pipes fore and aft convertor.

The starter is located on the passenger side of the transmission bell housing, where the transmission mates with the engine block.

You will need a special wrench to get the giant nut in the center off. It is torqued to 300+ lb-ft.

The sensor is located under the intake manifold. It takes about 2 and half hours to replace the intake manifold, book time. Knock sensor is about $35 + $60-$90/hr labor. So you are talking about $300.

The Bold and the Beautiful - 1987 1-300 was released on: USA: 1988

225 hp for the es model (non turbo) 300 for the AWD twin turbo

Bank 2 sensor 2 is located on the mid-pipe, below the car. That's the only one with a grommet that goes inside the car, below the passenger side carpet.

ok well in my twin turbo you would just have to take the water lines off the back and reach under the intake manifold on the back side, {if you have enough room}

under the dash on the left hand side is a plug for it, the plug is marked to unplug after 90, 000 miles do this and the light goes off hope this helps it is what the factory will do anyways oh and you do need to take the bottom half of the dash off under the wheel

it is located on the air filter hose secured with 2 hex screws. cant miss it

The mass air flow sensor is located on top of the air filter housing and is held in place by two screws. There is an electrical connector plugged into the sensor.


Copyright ยฉ 2020 Multiply Media, LLC. All Rights Reserved. The material on this site can not be reproduced, distributed, transmitted, cached or otherwise used, except with prior written permission of Multiply.