answersLogoWhite

0

Its on the throttle body. Its diamond shaped with two bolts in it.

User Avatar

Wiki User

17y ago

What else can I help you with?

Related Questions

Where is the idle air control valve on 2004 Taurus?

In the Engine Bay.


How do you adjust a fast idle on a 1989 Ford F150 302?

probably a bad idle air controller.


How do you replace idle air control valve on 2002 Ford Taurus?

remove it from the engine


Where is the idle air control valve on 2002 Ford Taurus?

It is located above the air filter intake opening


Where is the idle located in a dodge stealth 91?

the idc or idle air controller is located on the left of the engine under the throttle body


Why my Honda civic 2000 starts then idle drops and stalls?

Idle Air Control Valve.


Idle speed motor?

Normally refered to as an IAC (intake air controller) usual in the Throttle body. It controls the idle speed by regulating the amount of air that by passes the closed throttle body.


How do you fix the diagnostic trouble code p1507 for 1998 Ford Taurus?

Trouble code P1507 means: Idle Air Control Underspeed Error (see P0506) Trouble code P0506 means: Idle Air Control System RPM Lower Than Expected Replace the Idle Air Sensor


Where is the low idle screw on a 2002 Ford Taurus?

There is not a low idle screw. The computer sends a signal to the idle air control motor and it does the adjusting accordingly. If your idle is to high and your check engine light is on then you need to go to a repair shop and have them diagnosis the problem.


What is code P1504 on a 1996 Ford Taurus?

Trouble code P1504 means: Idle air control (IAC) circuit malfunction


Why does your 1985 25 liter celebrity like to die when idling?

I would clean, and possibly replace the Idle Air Controller. It regulates air to the engine to maintain an idle. It is bolted directly to the throttle body and will run you about $70 USD.


What causes your Ford Taurus 2002 to hesitate while at idle and when the air condition is on?

mine does that aswell, its normal to do that it will run below 1000rpm etc