Want this question answered?
the ignition module is located in the distributor
were is ignition drive module located in the engine
The module is located underneath the coil packs.
the ignition control modual is located on the backside of the fuse box under the dashboard.
Remove the wiring harness from your 1995 Chevy Blazer ignition control module. Remove the ignition control module retaining screws. Reverse the process to install your new ignition control module.
The ignition module is a small electrical part approx 3/4" x 1" that is located in the distributor by removing the distributor cap and looking for this small part that has about 4 wires going to it.
on 1994-95 Mustang v-8's the module is located on the passenger side fenderwell in front of the shock tower.
The ignition control module for a 1995 ford f150 is an important part of the drive train. If the module is failing then the engine will run erratically or not start at all.
Disconnect the battery. Remove the ignition coils. Remove the ignition control module that was under the coils, and replace it.
The ignition control module is located directly beneath the coil packs. These can be found at the rear of the engine, on the top center. Just look for where all the spark plug wires connect, those are the coil packs, and they are bolted to the ignition control module. It has three electrical connectors, two on the driver's side and one on the passenger's side.
ICM is located underneath the LH front shock absorber strut cover cup in engine compartment.
a '95 riviera does not have a distributor. If you mean the ignition coils, then you probably looking at bad ignition module-located under the coils. Or bad crank sensor.