Under coils
top right rear of engine.
Usually part of the switch (module)
The ignition control module on a 2001 Oldsmobile Alero is typically located on the engine, mounted on the ignition coil assembly. It is usually found near the front of the engine, close to the intake manifold. To access it, you may need to remove the engine cover and disconnect the electrical connectors. Always refer to a repair manual for specific instructions and safety precautions.
Where is the radiator cap located on a 2000 Oldsmobile Alero?
The thermostat is located on a 2003 Oldsmobile Alero in the thermostat housing. The thermostat housing is located on the rear side of the engine block.
where is the fourway flasher located ib a 2001 oldsmobile alero
To change the passlock module on a 2001 Oldsmobile Alero, first disconnect the negative battery cable to ensure safety. Remove the steering column cover by unscrewing the necessary fasteners, then locate the passlock module, which is typically positioned near the ignition lock cylinder. Disconnect the wiring harness from the module, remove any mounting screws, and replace the old module with the new one. Reassemble the steering column cover, reconnect the battery, and follow any reprogramming steps necessary for the new module to function properly.
In the fuel tank.
beside thermostat
By the battery.
The manual says to turn on the ignition.
Turn the ignition key on for 10 minutes and it will reset.