1994 was the last year the Ranger used an ignition control module on the 2.3 and 2.5. The ignition control module was attached to the lower intake manifold.
The 1989 Ford Ranger pickup truck ignition module is located on the firewall in the engine compartment. The ignition module will be on the drivers side of the firewall.
Where is the key in the ignition warning chime module located on a 1990 Ford ThunderbirdRead more: Where_is_the_headlight_warning_chime_module_located_on_a_1990_Ford_Ranger_2.9
its mounted under the hood on the driver side fender
On a 1997 Ford Ranger 2.3L, the ignition control module is typically located on the driver's side of the engine compartment, near the firewall. It is mounted on the ignition coil bracket, which is situated on the side of the engine. To access it, you may need to remove some components for better visibility and reach.
it's on the lower section of the distributor!
On a 1994 Ford Ranger with a 4.0-liter engine, the ignition module is typically located on the driver's side of the engine compartment, mounted on the side of the distributor. It can be found near the firewall, attached to the distributor housing. If you're having trouble locating it, consult the vehicle’s service manual for a detailed diagram.
Yes ( according to motorcraft.com ) Motorcraft ( DY 959 ) Ignition Control Module for 1995 Ford Ranger 2.3 L - SOHC
were is ignition drive module located in the engine
It is secured with screws at the fenderwell.
In a 1997 Ford Ranger, the wiper control module is located behind the radio compartment. It sits on the left side of the compartment.
The 1991 Ford Probe spark ignition module can be found on the firewall in the engine compartment. The ignition module will be on the drivers side of the firewall.
4.5 mm but has to be deepwell