0
What else can I help you with?
Where is the ignition module located on a 1989 ford ranger?
The 1989 Ford Ranger pickup truck ignition module is located on the firewall in the engine compartment. The ignition module will be on the drivers side of the firewall.
Where is the ignition module located on a Ford Ranger XLT 2.3l?
1994 was the last year the Ranger used an ignition control module on the 2.3 and 2.5. The ignition control module was attached to the lower intake manifold.
Does a 2000 Ford Ranger have a distributor?
No , the engines in a 2000 ford Ranger are E.D.I.S. ( Electronic Distributorless Ignition System )
Were is a window relay module on a 2000 ford ranger?
on the floor
95 2.3 ranger is it equipped with an ignition control module?
Yes ( according to motorcraft.com ) Motorcraft ( DY 959 ) Ignition Control Module for 1995 Ford Ranger 2.3 L - SOHC
Where is the location of the ignition control module on a 1993 Ford Ranger 2.3 dual ignition?
It is secured with screws at the fenderwell.
What is the Bolt size for ignition control module on a 1988 ford ranger?
4.5 mm but has to be deepwell
How do you bypass anti-theft system on Ford Ranger?
How do you bypass the alarm on a 2000 Ford ranger cause I replaced the ignition
Where is the ignition control modular on an 87 ford ranger?
The ignition module should be attached to the distributor with two small machine screws.
How do you replace the ignition module on 1994 ford ranger?
To replace the ignition module on a 1994 Ford Ranger, first disconnect the battery to ensure safety. Locate the ignition module, typically mounted on the distributor or nearby, and disconnect the wiring harness. Remove the mounting screws and take out the old module, then install the new one by reversing the steps, ensuring all connections are secure. Finally, reconnect the battery and test the ignition system.
Where is the headlight warning chime module located on a 1990 Ford Ranger 2.9?
Where is the key in the ignition warning chime module located on a 1990 Ford ThunderbirdRead more: Where_is_the_headlight_warning_chime_module_located_on_a_1990_Ford_Ranger_2.9
Can you adjust ignition timing on a 98 Ford Ranger 3.0 liter?
Yes ANSWER No - a 1998 3.0 L Ford Ranger does not have a distributor which would allow you to adjust the ignition timing - it has a coil pack and the ignition timing is controlled by the PCM ( powertrain control module )
