0
What else can I help you with?
Where is the ignition modular on 1996 Ford Explorer?
try under the front passenger seat
What would cause no control power to fuel pump relay on 1994 Ford Ranger?
In the absence of a fuel system shut off as in an alarm system I would suspect a fuel pump fuse, or faulty ignition switch
Where is the ignition control module on 1994 Ford Van E250 6 cylinder?
The only way I can explain it is to follow the wiring from your coil pack (where the spark plugs are) and the wires plug into the ignition module. Also go go www.wrenchead.ca and it has a manual that explains all. if you don't know the answer to a question please keep your moth shut ,please don't waste my time
How do you get the key out of the ignition of a 1988 ford ranger that will not go into park?
Shifter has to be in park to get the key turned all the way off,,,,,,,,,,,,, Why will it not go into park?,,, Contact me in my message board
How do you By pass securilock passive anti-theft system on 99 ford ranger?
You cannot bypass or reset the Securilock anti-theft system on a 99 Ford Ranger. If the system begins to malfunction and you can no longer start the vehicle, you will likely need to replace the transponder unit that is located behind the ignition in the steering column.
Where is the ignition control modular located on a 1996 ford ranger?
I believe under the distributor . It should have a plug attached to it.
Where is the ignition module located on a Ford Ranger XLT 2.3l?
1994 was the last year the Ranger used an ignition control module on the 2.3 and 2.5. The ignition control module was attached to the lower intake manifold.
Where is the location of the ignition control module on a 1993 Ford Ranger 2.3 dual ignition?
It is secured with screws at the fenderwell.
Install ignition 2002 Ford Ranger?
install ignition 2002 ford ranger directions
95 2.3 ranger is it equipped with an ignition control module?
Yes ( according to motorcraft.com ) Motorcraft ( DY 959 ) Ignition Control Module for 1995 Ford Ranger 2.3 L - SOHC
What is the Bolt size for ignition control module on a 1988 ford ranger?
4.5 mm but has to be deepwell
Can you adjust ignition timing on a 98 Ford Ranger 3.0 liter?
Yes ANSWER No - a 1998 3.0 L Ford Ranger does not have a distributor which would allow you to adjust the ignition timing - it has a coil pack and the ignition timing is controlled by the PCM ( powertrain control module )
Where is ignition control module on 94 ford ranger 3.0 6 cylinder?
On the lh side mounted to radiator
How do you identify the ignition system on a 89 ford F150 with a 302?
the ignition modular is on the driver side 6" from firewall
Where is the ignition control module located on a 1997 ford ranger 2.3L?
On a 1997 Ford Ranger 2.3L, the ignition control module is typically located on the driver's side of the engine compartment, near the firewall. It is mounted on the ignition coil bracket, which is situated on the side of the engine. To access it, you may need to remove some components for better visibility and reach.
Where is the ignition modular on 1996 Ford Explorer?
try under the front passenger seat
Where is the ignition module located on a 1989 ford ranger?
The 1989 Ford Ranger pickup truck ignition module is located on the firewall in the engine compartment. The ignition module will be on the drivers side of the firewall.
