answersLogoWhite

Top Answer
User Avatar
Wiki User
Answered 2008-09-13 15:42:00

Right under the ignition cap.

001
๐Ÿ™
0
๐Ÿคจ
0
๐Ÿ˜ฎ
0
๐Ÿ˜‚
0

Your Answer

Related Questions


The 1999 Chevy S 10 pickup truck ignition module can be found on the firewall in the engine compartment. The ignition module will be on the drivers side of the firewall.


The engine computer is the ignition module.


How do you remove the dashboard fascia on a 1999 Chevy Astro?


The 1999 Chevy Astro horn relay switch can be found on the back of the horn. The relay switch will be attached to the horn with two retaining screws.


Remove the retaining ring from the top of your 1999 Chevy Cavalier ignition switch. Slide the ignition switch out and remove the wiring harness from the end of it.



The PCV valve on a 1999 Astro should be located on top of the valve cover. It plugs in and can be easily replaced.


Try the installdoctor.com. Worked for me.



The AC low side service port on a 1999 Chevy Astro van is located next to the firewall. It is the port that is closest to the evaporator.


The Ignition control module is mounted under the hood. It is on the fire wall right beside the hood strut,


I haVE A 1999 CHEVY astro and it holds just over 25 gallons. once ran out of gas and then had it filled.



Yes. The lug pattern is the same on all Astro vans up to 2001. 2002 they went to a six lug pattern.


On top of the RH Side of the Engine. You will need to remove the engine cover from the inside of the van to get to it. Just trace the coil wire from the distributor.


Engine diagrams can be used as guides when it comes times to making necessary changes. An engine diagram to a 1999 Chevy Astro Van can be found in its maintenance and repair manuals.


If you're looking for a stand-alone ignition controlmodule, there isn't one on the Windstar.This job has been transferred to the Powertrain Control Module (PCM) and its direct control of the coilpack.


My 95 Chevy Astro van averages 15 mpg in the city. I do not know what it gets on the highway. It has a 4.3 L V6.


Remove the positive battery cable from your 1999 Chevy Astro battery. Disconnect the cables from the front of the starter. Remove the starter retaining bolts. Reverse the process to install the new starter.


the 1999 Chevy venture does not have distributor cap, he has a electronic module assembly, assembly is module and three coils, they are located on the top of the engine, back in the medium near of the firewall.


What engine? Ford contour 2.0L DOHC eng. distributorless ignition are controlled by the main PCM There is an ignition module on the 99 contour 2.0 with automatic transmission. It is shown in the schematics for this model.


typically this means the ignition module is bad


Mounted on top and inside the fuel tank.


The map sensor on a Chevy venture is located under the ignition module on top of the rear cilinder bank. To access it you have to remove the ignition module. It helps a bit if you rotate the engine forward and you can lower the engine for about 4 inch. you will have to unbold the subframe on the frontside, use a hydraulic jack to take the weight and lower it carefully. this gives you the extra space needed to work on it.


depeding on what yr it is ... mine being a 1999 is mounted right next to the coil . on the passengers side of the motor . cost me 70 bucks at O'Reilleys



Copyright ยฉ 2020 Multiply Media, LLC. All Rights Reserved. The material on this site can not be reproduced, distributed, transmitted, cached or otherwise used, except with prior written permission of Multiply.