The engine computer is the ignition module.
loose wire or most likely ignition module
The 1999 Chevy S 10 pickup truck ignition module can be found on the firewall in the engine compartment. The ignition module will be on the drivers side of the firewall.
Right under the ignition cap.
Inside the distributor
The Ignition control module is mounted under the hood. It is on the fire wall right beside the hood strut,
To replace the ignition module on a 1999 GMC Suburban, first disconnect the negative battery cable to ensure safety. Remove the distributor cap and rotor to access the ignition module, which is typically mounted on the side of the distributor. Disconnect the electrical connectors and unbolt the module from the distributor. Finally, install the new module, reassemble the distributor, and reconnect the battery.
It is part of the engine computer.
On a 1999 Harley-Davidson 883 Sportster, the ignition module is typically located under the seat, mounted to the frame. To access it, you'll need to remove the seat by unscrewing the bolts securing it in place. The ignition module is a rectangular box connected to the wiring harness, usually near the battery area.
typically this means the ignition module is bad
What engine? Ford contour 2.0L DOHC eng. distributorless ignition are controlled by the main PCM There is an ignition module on the 99 contour 2.0 with automatic transmission. It is shown in the schematics for this model.
you take it to the dealer caz you cant do it for sure its incredably complicated
If you're looking for a stand-alone ignition controlmodule, there isn't one on the Windstar.This job has been transferred to the Powertrain Control Module (PCM) and its direct control of the coilpack.