0
What else can I help you with?
Hyundai scoupe 1991 why your electric radiator fan don't run?
where is the cooling fan relay switch located on a 1991 Hyundai scoupe ls 4 cylinder 1.5 liter engin
How do you change the ignition switch in a 1992 Hyundai Scoupe?
you have to pull the steering wheel off. pull turn signal housing off. on top of ignition switch there are two bolts which are smooth on top so you have to take a punch and knock them loose. take them out
Why can't i pull the key out of the 93 hyundai scoupe. It sticks sometimes when i put it in park and it won't come out until i play it it for a while.?
You may have too much play in your ignition switch.
Where is the ignition switch on a 1997 Hyundai Accent and how do you change it?
changeing ignition barral
Why would the fan on a 1994 Hyundai Scoupe keep running after the car is turned off?
A bad relay in the fan's circuit could cause this. I have a 94 Hyundai Scoupe and I just had to replace the thermo switch attached at the bottom of the radiator. Had the same problem. Fan wouldn't go off....ever.
Where is the ignition switch located on a 1986 Nissan 300ZX?
when you start the car up that's your ignition switch is located...
Hyundai Elantra no crank and than it starts?
The ignition switch could be bad if a Hyundai Elantra has no crank and then starts. The fuses which are tied to the ignition should also be checked.
2010 Hyundai Sonata have a overdrive switch?
does the 2010 hyundai santa fe have an on off overdrive switch where is it located
How do you change the ignition switch on a 2002 Hyundia Accent?
To changeÊthe ignition switch on a Hyundai Accent, first, one should remove the switch from the steering column, to which it is attached. From there, the component can be replaced.
Where is the ignition switch located on a 1992 VW?
the ignition switch is the key and its on the stering collem or on the dash
Where is the ignition switch located on 1997 Oldsmobile bravada?
The ignition switch is located inside the steering coulum below the key and tumbler.
How do you remove and install the ignition switch on a 2008 Hyundai sonata?
To remove the ignition switch on a 2008 Hyundai Sonata, first, disconnect the negative battery cable. Then, remove the steering column covers and the ignition lock cylinder by turning it to the "Run" position and pushing the release pin. After that, you can unscrew and detach the ignition switch from its mounting. To install, reverse the process, ensuring the new switch is properly aligned before securing it in place.
