its underneath the hose comming out of the intake about 5 inches out
A 1995 blazer does not have a crank sensor. SORRY
In mass air flow sensor.
There is no Intake Air Temperature sensor on a 1995 only 96 and newer. If you are asking because you are putting some sort of performance module on it then you need to hook that up to the Coolant temperature sensor which is located next to the thermostat and it is a two wire sensor.
The temp sensor for the ECM (engine control module) is next to the thermostat housing.
Check the air filter box.
IAT= intake are temperature sensor ECT= engine coolant temp. sensor
That sensor was not used on that year. IT DON'T HAVE 1
Only the 1996 and newer Honda's have a i.a.t sensor. It is located in the air intake tube that runs to the throttle body/intake manifold.
on the themostat housing where the upper rad hose meets the intake manifold
If you mean the IAT (Intake Air Temperature) sensor, it's on the intake manifold (passenger side) on the Cylinder 2 runner towards the front.
On a 1995 Chevy 1500, the Intake Air Temperature (IAT) sensor is typically located on the intake manifold or in the air intake duct, often near the mass airflow sensor. It is usually mounted in a way that allows it to measure the temperature of the incoming air efficiently. To locate it, look for a small sensor with an electrical connector attached to it.
Look where the thermostat is attached to the intake manifold