The 2002 Jeep Liberty came equipped in four engine options. For the 3.7L V6 the intake air temperature (IAT) sensor is located in the intake air assembly. It will be forward of the throttle body, which is the assembly that regulates air intake via its butterfly valve. The OE replacement IAT for this application is Standard Motor Products #AX69.
The 2002 Ford Escort zx2 does have an air intake air temperature sensor. The sensor is at the top of the engine on the drivers side.
The intake air temperature sensor is under the intake manifold on the 2002 Land Rover Freelander. It is on the top rear section of the engine.
The temperature gauge sensor on the 2002 F150 is located on the driver's side of the vehicle and under the intake. This is almost impossible to remove without removing the intake itself.
For a Liberty 3.7L engine, the Intake Manifold Air Temperature (IAT) sensor is installed into the left side of intake manifold plenum. Prior to removing this, ensure to clean around the unit so dirt doesn't fall into the opening. Removal is about 1/4 counterclockwise turn.
It is integral with the Maf sensor on the air box
It is on the intake manifold near the thermostat housing.
On a 2002 Dodge Intrepid, the intake air sensor, commonly referred to as the intake air temperature (IAT) sensor, is typically located in the intake manifold or air intake duct. It is often positioned near the air filter or throttle body, where it can accurately measure the temperature of the incoming air. To locate it, look for a small sensor with an electrical connector attached to it along the air intake path.
The rear of the generator, right on the manifold
The intake air temperature (IAT) sensor on a 2002 Ford Focus is typically located in or near the air intake manifold. It is often found in the intake duct, close to the air filter or throttle body. In some configurations, the sensor may be integrated into the mass airflow sensor (MAF) assembly. Always refer to the vehicle's service manual for the exact location and specifications.
It is located on the intake manifold near the thermostat housing.
The intake air temperature (IAT) sensor on a 2002 Chevy Malibu is typically located near the air intake duct or the air filter housing. Its purpose is to measure the temperature of the incoming air to the engine. This information is used by the engine control unit to adjust the air-fuel mixture for optimal performance and efficiency. It is crucial for the sensor to be placed as close to the intake manifold as possible to provide accurate readings.
It is on the intake manifold near the thermostat housing.