0
What else can I help you with?
How many 02 sensors in a 2002 Mercury Villager?
There are two.
What other van doors are interchangeable with a 2000 mercury villager?
1999-2002 Villager or Nissan Quest.
Where is the knock sensor on 2002 Mercury Villager?
The knock sensor is in the engine V under the intake manifolds and coolant crossover pipe. As it requires considerable disassembly and an expensive new gasket set to reach it, I suggest you make very sure there is something wrong with it first. You will have to remove the upper and lower intake manifolds and coolant crossover pipe assembly to reach it. Just because you are receiving a trouble code for it does not mean there is anything wrong with it. This sensor shares a circuit with other components that often will set a "ghost" trouble code.
How do you get the engine codes on a 2002 mercury villager?
Plug in a scan tool.
What years of radiator will fit 2000 mercury villager?
1999 - 2002.
Whats the size of the tank on the mercury villager?
After looking at the ( 1996 , 1999 , and 2002 ) Mercury Villager Owner Guides : The fuel tank capacity is ( 20.0 U.S. gallons / 75.7 liters )
How is the heater resistor in a 2002 mercury villager repaired?
If it is defective it will need to be replaced.
Does the 2002 mercury villager have a speedometer cable?
No, the speedometer is driven electrically from the PCM.
Where is the signal relay located in a 2002 mercury villager?
By the fusebox under the dash.
How do you change thermostat on 2002 mercury villager can't get bolts off?
To change the thermostat on a 2002 Mercury villager, pull the hose away. If the bolts do not come off, wiggle the fitting to expose the thermostat to be able to change it.
How do you take out the knock 1 sensor in a 2002 mercury villager?
The knock sensor is in the engine V under the intake manifolds and coolant crossover pipe. As it requires considerable disassembly and an expensive new gasket set to reach it, I suggest you make very sure there is something wrong with it first. You will have to remove the upper and lower intake manifolds and coolant crossover pipe assembly to reach it. Just because you are receiving a trouble code for it does not mean there is anything wrong with it. This sensor shares a circuit with other components that often will set a "ghost" trouble code.
How hard is it to change a knock senor on a 2002 mercury villager 3.3?
The knock sensor is in the engine V under the intake manifolds and coolant crossover pipe. As it requires considerable disassembly and an expensive new gasket set to reach it, I suggest you make very sure there is something wrong with it first. You will have to remove the upper and lower intake manifolds and coolant crossover pipe assembly to reach it. Just because you are receiving a trouble code for it does not mean there is anything wrong with it. This sensor shares a circuit with other components that often will set a "ghost" trouble code.Read more: How_do_you_replace_the_knock_sensor_in_a_1996_mercury_villager_van
