Want this question answered?
It is the kill switch
A loose kill switch wire on your out board motor will cause the engine to lose power. As the kill switch loses contact the motor will begin to bog down or completely quit.
Isolate the wire going into kill switch [wrap some tape round it] so it cannot be earthed.
A kill switch is usually nothing more than a common toggle switch. It is usually installed in a hidden place and is used to disrupt electrical power to the starter motor.
Hit the kill switch or release the clutch with the throttle closed
Change oil. Turn motor ignition switch to on but don't start Pull off emergency kill switch plate Pull emergency kill switch 3 times in less than 7 seconds. Replace kill switch plate. Done.
A kill switch is used to disable the motor of a jet-ski if the rider falls off.
It does not have a kill switch.It does not have a kill switch.
The KILL switch is in series with the ignition switch. When the KILL switch is open, the bike will not start.
If not getting spark push the kill switch on the the lanyured and should start but if you left fuel in it the fuel might be bad so clean that out first then push the kill switch DON'T BUY NEW COILS BECAUSE IF JUST MIGHT BE THE KILL SWITCH
Chrysler does not have a kill switchChrysler does not have a kill switch
if the kickstand is down, the safety switch will kill motor. or it may be defected.