answersLogoWhite

0

Where is the knock sensor in a 97 Subaru Outback?

Updated: 8/16/2019
User Avatar

Wiki User

14y ago

Best Answer

the knock sensor in on the drivers side of the block toward the rear, and it's under the intake manifold.

User Avatar

Wiki User

14y ago
This answer is:
User Avatar

Add your answer:

Earn +20 pts
Q: Where is the knock sensor in a 97 Subaru Outback?
Write your answer...
Submit
Still have questions?
magnify glass
imp
Related questions

How can I find a 1997 Subaru legacy outback ltd owner's manual?

check this link, it did helped me get info on my 97 subaru outback. http://hp.auto.ru/Subaru%20Legacy/1997/ cheers!


Where is the knock sensor located on a Mitsubishi eclipse 97?

where is located theknock sensor 97 mitssubishi eclipse


How do you replace the main window switch on a 97 subaru legacy outback?

i dont know what am i crazy


What kind of mileage do you get in a 1997 Subaru Outback?

I Have A Beautiful 97 Outback with 81,000 Miles I get 23 to 24 in city and 26 28 on hwghy.


How do you install knock sensor in a 97 ford expedition?

On the 5.4 the knock sensor is under the intake and the connector is in the back of the motor on the passenger side.


Diagnosing engine knock in 97 astro van?

check the anti knock sensor on the side of the motor


Where is the knock sensor located on a 97 Honda civic ex?

ihsiqwhdiqwehudhejkdjbdjkgbekd


How can you tell if the spring on a strut is still good on subaru outback 97?

If the spring is not physically broken, it is probably still good.


Where is the knock sensor on a 97 diamante?

Your knock sensor is located under the hood, center, front engine area, below intake manifold, mounted on block.


Where is the knock sensor in a '97 Expedition?

if you have a 5.4 or a 4.6 it is under the intake manifold on the passenger side.


How hard is it to replace the knock and throttle position sensors on 1997 outback?

I replaced the knock sensor on my '97 OBW. I used a 12 mm socket with an extension to remove the bolt that is under the intake manifold. You can use a piece of bent coat hanger to fish the sensor and the wire so you can work on it. The sensor just plugs in so removal is not really difficult. then place the sensor back on the top of the engine and re-install the bolt. Be careful and take your time and it can be done.


Where is knock sensor 97 Yukon?

It is screewed into the passenger side of the engine block just in front of the starter.