The knock sensor is in the engine V under the intake manifolds and coolant crossover pipe. As it requires considerable disassembly and an expensive new gasket set to reach it, I suggest you make very sure there is something wrong with it first. Just because you are receiving a trouble code for it does not mean there is anything wrong with it. This sensor shares a circuit with other components that often will set a "ghost" trouble code.
Read more: Where_is_the_knock_sensor_in_a_1996_mercury_villager
It is under the intake manifold.
Where is the knock sensor for a 99 pathfinder
where is knock sensor located on a 99 Silverado 1500 4.3
The knock sensor is in the lifter valley
According to a website I was looking at : For a 1999 Mercury Villager : ( 15 to 17 in the city and 21 or 22 on the highway ) * miles per U.S. gallon
where is the location of the vehicle speedometer sensor on a 99 Mercury Mountaineer
cougar 99 where is coolant temperature sensor
Were is locate the snock sensor of chevi malibu 99
knock sensor location is under the intake manifold you have to remove intake their is two knock sensors front and rear
The knock sensor for a Honda CR-V 99 is located on top of the engine, under the intake. It is right beside of the number one cylinder.
In a 1999 Mercury Sable, the knock sensor is typically located on the engine block, near the intake manifold. It is usually positioned on the driver's side, towards the rear of the engine. To access it, you may need to remove some components for better visibility and reach. Always refer to the vehicle's service manual for exact locations and procedures.
On a 1999 Oldsmobile Alero, the knock sensor is located on the engine block. It may be bolted to the intake manifold, or to either side of the block.