0
What else can I help you with?
Where is the knock sensor located on a 1990 Toyota pickup 30L 3VZE?
it's located under the intake manifold. the knock sensor is most likely ok' the porblem is the short wiring harness from sensor to main wire harness.
Where is the knock sensor on a 1991 300zx 2 2 non turbo?
The knock sensor on Nissan 300ZX non-turbo from 1990 thru 1996 is located below the lower intake manifold on the rear of the engine block. To replace the knock sensor the upper and lower intake manifolds need to be removed. It is always best to replace the knock sensor with a new one considering its major dissasembly.
Where is the voltage regulator located on a 1990 Chevrolet Silverado?
It is located in the alternator.
Where is the knock sensor on 1989 Chevy Celebrity 2.8?
The knock sensor on a Chevy Celebrity 2.8 L engine from 1987 thru 1990 is located on the back side of the engine(next to the firewall) below the exhaust manifold. There are actually two sensors there, one is the knock sensor, the other is the crankshaft position sensor. The knock sensor is threaded into the block with a pipe thread, the crankshaft position sensor is held in with a 10 mm screw and is near the center of the block. They are both accessible with the engine in the car, but they are a bit of a pain to get to.l
Location of the iat sensor on 1990 Chevy silverado 4.3l v6?
They were not used on that year.
Where is the camshaft position sensor located on 1990 Lexus ls400?
Where is the camshaft position sensor located on 1990 Lexus ls400?
Where is the Mass air flow sensor 1990 Chevy silverado?
That year did not have one. No need for it on that one.
Where is the anti knock sensor on a Chevy 350 block?
It is in front of the starter on my van.1990 350
Where is the modulator on a 1990 Chevy Silverado?
the modulater on a 90 shevy silverado is located under the dashboard mounted on the steering colum
Where is the knock sensor on a 1990 Nissan 240sx?
The knock sensor on a 1990 Nissan 240SX is located on the engine block, specifically on the left side near the rear, typically below the intake manifold. It is positioned to detect engine vibrations and send signals to the ECU for ignition timing adjustments. To access it, you may need to remove the intake manifold or other components for better visibility and reach.
Where is the knock sensor located on a 1990 Chevrolet pickup 4 wheel drive?
It is screewed into the side of the engine block, Just in front of the starter on the passenger side. It is alittle hard to see.
What is the sensor above the 350 engine oil pan and starter on your 1990 Chevy c1500 truck?
oil pressure switch or knock sensor
