0
What else can I help you with?
Where is the anti-knock sensor on a 2003 Chevy Avalanche?
you mean knock sensor
Where is the Anti knock sensor on 1995 Chevy Suburban?
Should be on the passenger side of the engine screwed into the block by the starter. It is below the exhaust manifold.
What is the anti knock sensor on a Chevy 350 for?
It signals the computer to reduce the ignition timing.
Diagnosing engine knock in 97 astro van?
check the anti knock sensor on the side of the motor
92 Toyota pickup v6 engine anti knock sensor location?
Ah, the anti-knock sensor on your 1992 Toyota pickup with a V6 engine is located near the engine block. It's a small, important part that helps prevent engine knocking and keeps things running smoothly. Just take your time, be gentle, and you'll find it nestled in there, doing its job to keep your truck happy and healthy.
Where is the anti knock sensor on a 2004 Chevy 4.8 V8?
There is two of them,and they are under the Intake manifold.You will have to remove the intake to even see them and to remove them.Bad place for GM. to put them.
Can the knock sensor cause overheating and loss of anti-freeze?
Overheating, yes. Loss of antifreeze, no.
What is the wire on the front hub of a 2000 Chevy Tahoe 4wd?
That is the anti locking brake sensor / wheel speed sensor
Where is the anti lock brake sensor located on a Chevy Tahoe?
in front of the wheel bearing your anti lock brake system sensor should be, im having the same problem
Where is anti lock sensor locate in 98 discovery?
on the alumman block that is next to the brake master or its part of the wheel bearing
Would a blown head gasket make a motor knock?
yes but if it is a blown head gasket it will make it miss and put steam and some water out the tell pipe if its not doing these things then check your anti knock sensor
Could a anti knock sensor that is unplugged or defective cause problems with the 305 motor starting?
No, a faulty knock sensor will cause a code 43 normally. check for spark, diconnect a wire from a plug, install a plug in the wire, lay it on something metal, have an assistant crank the motor and watch for spark...
