0
Some of the 1992 Rangers had the camshaft position sensor on top of the engine in the same hole where the distributor used to be. Some Ranger engines did not use a camshaft sensor at all.
Wiki User
∙ 9y ago
Add your answer:
Earn +20 pts
Where is the daytime running lights module location on a 1992 ranger?
The 1992 Ford Ranger did not come equipped with daytime running lights.
IAT sensor location on 2004 Ford Ranger 2.3L?
It's located with the MAF
Coolant temp sensor location on 2001 ford ranger 2.3l?
yes yes
Location of knock sensor on 4.0L 93' ford ranger?
It doesn't have a knock sensor on the 4.0 L OHV in a 1993 Ranger ( my 1995 Ford Explorer 4.0 L OHV engine doesn't have a knock sensor either )
97 2,3 vina engine ford ranger xlt map sensor location?
Radar
What is the sensor located on the back of the head on 1992 ford ranger with 2.3 L engine It happens to be leaking oil.?
Its the oil sensor.
Where is the rev counter sensor for a Ford Ranger 2.5TD?
Where is the ford ranger 2004 revcounter sensor conected
1986 Ford Ranger 2.9l knock sensor location?
Drivers side engine block above starter.
How do you replace the fuel filter on a 1992 Ford Ranger?
where is fuel filter located on a 1992 ford ranger
Map sensor location 1995 Ford Ranger?
It doesn't have one .It has a mass air flow sensor in the air intake tube to the air cleaner .
How do you reset the gas pump setting on a 1992 ford ranger?
Fill it up. If it stays on with a full tank, then the sensor is bad.
Where is oil shut off sensor switch located on a 1992 ford ranger?
There isn't a sensor that will shut off the engine if the oil pressure is too low
