Drivers side, below break fluid resevoir, between compressor and firewall ---See Below--- The low-pressure port usually has a blue or black dust cap and is located on the larger diameter metal tubing that runs between the evaporator (in the dashboard) and the compressor. To locate the low-pressure port: # Find the compressor. # Find large diameter metal tubing that leads from the compressor back to the fire wall. # Find port on this tube. Our quick-connect coupler should fit onto this port. To be sure, compare with the port on the other tube (smaller tube) that leads from the compressor to the condenser near the radiator. This port is larger and is the High Side port. Our quick-connect coupler will NOT fit on the High Side port. # Do not attempt to connect to the high side port as this can cause a can of refrigerant to explode. # Sometimes the low side port is on-or-near the compressor, sometimes it's on an accumulator near the firewall…not on the large diameter metal tube.
it on the fire wall
a drill.
it is an inline filter located on the fire wall under the master cylinder.
back fire ,disolin
Usually on the fire wall, passenger side.
The rap module is located on the fire wall behind the radio of the 2000 Ford Expedition. Rap module stands for remote anti-theft personality module.
its mounted on the fire wall with a vacuum hose coming from the throttle body to it
It is located close to the fire wall on the drivers side of the engine compartment.
on the fire wall located behind the motor Like the other person said, on the firewall. Right next to the battery.
resistor module is on the right side below the dash next to the heater motor next to the fire wall you will have to remove a kick panel by the glove box
The rap module is located on the fire wall behind the radio of the 2000 Ford Expedition. Rap module stands for remote anti-theft personality module.
Portland Fire was created in 2000.