The low pressure switch for a 1989 Honda Prelude 2.0Si is typically located on the air conditioning system's accumulator or receiver-drier, which is situated near the front of the engine bay. It may also be found on the A/C compressor itself. To access it, you may need to remove any obstructing components, so ensure the engine is off and the A/C system is discharged before attempting any work. Always consult the vehicle's service manual for precise location and safety instructions.
The 1989 Honda Prelude had 4x100mm offset. The 1989 Nissan 240sx has a 4x114.3mm offset...so, it will not fit.
How do i take the fuel filter off my honda prelude si 1989
I have a 1989 prelude si and im pretty sure there 15s
The starter on the 1989 Honda Prelude is located on the left side of the engine. It is under the radiator hose that is at the rear of the radiator.
Please reask question: Where are the VALVES ON A 1989 HONDA? How many VALVES ON A 1989 HONDA? How do I adjust the VALVES ON A 1989 HONDA?
No, they are different.
Yes, this switch must be activated to allow the engine to start. If this switch has failed, it may function improperly or not at all.
None of the dashboard lights work on my 1988 Prelude. Why?
135
The fuel pump on a 1989 Honda Prelude is located in the fuel tank. Being close to the tank allows it to pump gas more readily to the engine.
buy a hanes book
Qty. four...