It's located on the passenger side firewall area by the a/c air dryer (long round canister looking thing). It has a hose attached to it that goes to the intake manifold. Chances are the sensor is good and ur turbo is stuck and needs cleaning. Good luck.
The MAP sensor is located on intake manifold.
The Manifold ?æAbsolute Pressure sensor is located on top of the manifold. It is just forward of the intake manifold and held in place with a bracket assembly.
The manifold absolute pressure (MAP) sensor, is located on or around the intake manifold, and provides constant information concerning the amount of pressure inside the intake manifold.
The oil pressure sensor is under the intake manifold on a 3.6L.
This is the Manifold Absolute Pressure sensor. It is located on the top of the motor between the fire wall and the intake manifold case.
The manifold absolute pressure (MAP) sensor is an important component to your 1994 General Motors Blazer/Jimmy's EFI system. This pressure sensor is located provisioned into the intake manifold assembly.
the map sensor is located on the air intake manifold on the left side under the throttle position sensor on the 2.2 4 cyl. motor.
the sensor is under the exhaust manifold at the rear of the engine
It does not use a MAF. It has a MAP sensor (manifold absolute pressure) on the front of the intake manifold.
The Manifold Absolute Pressure (MAP) sensor is located near the throttle body on the intake manifold.
on top of the aluminum intake manifold, back near the firewall.
The Manifold absolute pressure sensor on a fiero V6 is mounted on the passenger side manifold right beside the thermostat assembly/water outlet